Wireless

Hi,I'm looking for documentation that states what the practical limit is for the number of clients per AP.The only thing that I have found is on the FAQ that states, generally, that the AP is capable of 2048 MAC addresses and performance decrease as ...

I like to design one fixed root-bridge and shiftable non-root bridge.The root bridge have Omni antenna and non-root bridge also have omni antenna. but important issue is non-root bridge is installed in the bus. bus is moving around in root-bridge's o...

Hey everyone,We have a dozen or so Aironet 1200 series Access Points and I am trying to find a way to have the APs send the WEP key to the clients so we don't have to manually visit each client and put in the WEP key. We have a lot of visitors that ...

Hi, i experienced some problems with MAC address filtering to allow only several clients cards to associate. I was using the 1200 with 12.2.8 IOS.In the association table the client was not visible, but the ACU software on the client said it was asso...

When configuring a repeater access point, the log file displays the following messages: "associated to parent [aaaa]""reassociate response from parent [aaaa]"several times in a second (never stop), and the following warning message appear:"failed to ...

Since several days ago Im having intermitent connection problems with the wireless linked network. I see in the log things like "Too many retries", "too many missed beacons" "Lost associations" etc. What might be causing this. I have tried changing f...

I have a large complicated bridged network between buildings. I have noticed periodically during the day, such as 7:20 am (probably offices logging in) and then another one at approx 6pm (I am guessing a backup of some sort) where the continuous pi...

We have been working with an open authentication environment one year, with 10 AP350. Now we have changed the configuration, configuring LEAP in clients, and Mac and user authentication with an ACS. We have two problems:The worst is that there are fe...

I'm having a problem that started recently with my WLSE. Whenever a fault occurs with an AP, I receive the standard "Device was not reachable by SNMP" error message. I'll check out the problem and correct it but the fault will not clear from the "D...

Hiif anyone can helpo it would be great.I I using a cisco 350 within our building for laptops users.We are using no servers for authentication.I want to only allow our mac addresses to authenticate with the access point.I also want to encrypt our dat...

Hello,I am setting MAC filters on my AP 1230. Althought it seem to be working, when I enter a MAC I see no errors at all but when using both the IOS or browser to see my current configuration I see different MAC addresses than the ones I type in the ...

I have an 1200 series AP, and when i try to associate it as a repeater, it associate and disassociate many times per second, and after a while, it gets blocked or shuts down. I have configured the same authentication type for both (root and repeater)...

Hello all.I have an aironet 340 access point and several aironet pcmcia client adaptors. I have a laptop running win nt4 server and the rest running win nt4 client. How should I connect and setup the various devices such that all these laptops can fo...

Dear Sir,Does the AP handle load balancing dynamically?I know that the client will switch to another AP based on the signal quality level detected and not on signal strength. How about the utilisation on the AP? Will this play a role? If I have 3 APs...

I have a bridge that I'd like to use as repeater to connect to an AP in root mode. Is it posible to do this? or viceversa? The access point (in non-root mode) connecting to a bridge in root modeThanks!