IP Telephony and Phones

currently using v17.03.01a on a ISR4351/K9 CUBE.Want to know if it possible to configure syslog over tls.Read in the past that it is not supported on most cisco devices.

Hello,We are trying to configure an Access Point (c9105AXW-E)  port with an IP PHONE (Unify).  I took a debug client on the wlc of the phone and we reviewed the log and all seems ok as we can see even the DHCP seems fine yet we cannot get the phone t...

I hve a client claiming that when she receieved an incoming call , her phone does not ring only flash .she has no problem receiving and making calls but just no ringing tone for incoming call . she resolved it by resetting the phone.Does anyone hve t...

Hi Everyone,   We've had a request to disable all call history on 3 Cisco 7821 as these phone are in area's which they don't want people to access the recent call history.   I've managed to disable the recent soft key button on the phone itself and I...

Hello,I am currently testing the Wireles Phone 840 and 860. I initially used a PSK SSID to register and provision them on the CUCM. That works so far. I have installed an LSC and set the device to encrypted.For production, however, I would like to us...

Hello all,We haven't faced this issue before only it started last month and recently it is being frequent that every day we are experiencing busy tone on all outgoing calls but no issue when it comes to internal (extension) and also tested incoming c...

There there.  Got a weird one.  One of our customers has ordered 4 x 6825 Dect phones which I've added to CUCM successfully as 3rd Party Devices and they are taking calls fine. The issue is that the on all of them the volume/mute buttons on the side ...

I am the administrator, I am logged in to Cisco Finesse Administration. Trying to delete a Reason Code but the delete button is grayed out. The New and Edit button are available.All the documentation says I should just be able to click Delete.

I recently upgraded a Call Manager cluster from 11.5 to 12.5 SU5.The cluster consists of a CUCM Pub and 2 CUCM Subs.The upgrade seemed to go fine, no issues. Afterwards I noticed the DRS backups were reporting a error where the PLM feature failed.In ...

I have a bit of a convoluted setup but the actual issue is fairly straight forward. My 'lab' (i.e. home network...) is connected to the Internet via a consumer FTTP connection fronted by a Cisco C921-4P PPPoE router.  The service provider I was signe...

Dears, In the last models of CME (2900, 3900, 4300, 4400), there was an option to configure the welcoming message (Automated Attendant), either through Cisco Unity Express (which is now EOS), or B-ACD service, I was wondering of how can we have this ...

We have a few offices that we need to have ATA and printer connected to the same switch port on Meraki MS. The port is configured in access mode and allows traffic for VLAN x (data) and VLAN y (Voice). we have the ATA connected to switch port and usi...