Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Greetings everyone,I'm having difficulty finding the correct command sequence to add phone extension numbers via the CLI. The CUE GUI is set to now allow new extensions via the GUI, so I'm stuck adding them in the CLI. I"m using CUE 7.1.5.Any help w...
Hello, I have a cisco 3825 gateway and would like to add a second PRI. I have configured the Call Manager gateway to take the second PRI on 0/2/1. When I looked at the configuration on the 3825 gateway I got confused when I saw Dial-peer with po...
Hi,I think this may be a known issue with these phones but does anyone know of a fix?The phones are on public IP's but I have disabled port 80 on the firewall as connecting to the config page seems to cause the phone to run out of memory reboot reaso...
I'm having issues dialing a single number.9, 1-714-901-XXXXNow I can dial this number no problem from a cell phone or another phone system.I can dial other 714-901 numbers just fine from my system. Just not this one number.I did a dialed number analy...
Does any one can tell me what web functional can modify enduser pin password !!thanksHappy new yearharvey
Hi all, I have been scratching around CCO looking for the UK dial plans along with User Local for the UK and can not find them, could somebody please link to them so I can stop myself going crazy here..Thanks all
Hi Is there a way to increase the timeout of the ccmuser page in CUCM 7.x? Cheers Peter
my uc 520 is sending unknown as the outbound caller id name, outboung caller id number is working fine.here is the serial config which is where i think the problem isinterface Serial0/2/0:23no ip addressencapsulation hdlcisdn switch-type primary-5es...
Hi all,Currently I want to know that which question we should ask if we are currently running a PBX system and we want to integrate this with CUCM7.0. What are the all details that we should know. So that we plan the installation and the require numb...
Hi, I am trying to configure the auto qos for the IP communicator (auto qos voip cisco-softphone) but am unable to find the configuration.I have checked the IOS version release notes and the command is not listed, would anybody be able to let me know...
People,please help me,My router is registred with sip trunk provider , but i canot make calls out , i saw with the command "sip-ua register status" that there are some peers,why that?And why the my ID of the sip account is the peer -1?Line ...
HiI was hoping someone here could point me in the right direction, we're trying to upgrade from 4.2 to 7.1.5, unfortunately whenever we try to run the DMA we get the error[10:33:11 AM] Beginning Cisco CallManager export from xx.xx.xx.xx. (IP removed)...
We have Crestron at the conference room and are not able to make conference call. The Crestron pluged to VG 224 (MGCP) to CUCM 7.1http://www.crestron.com/downloads/pdf/product_manuals/tpmc-8x.pdf It worked before we move from Nortel system to CUCM ...
i know there is a url that you can use to view a deskphone display. i know about browsing a phone and seeing all the configurations but i want to view the deskphone display.URL....IP address/somthingAnyone know that one?Thanks,Andy
I have a site with a full T1 PRI for voice using mgcp, CUCM 7, 2 subscribers (one is at this location), 1 publisher. There is no pots connectivity/redundancy at all at this site. Today we had a power issue caused by a problem with a transformer on ...
