IP Telephony and Phones

My customer is using UCM 7.1.2 and 2 3845 vgws (1 has local PRI and 2nd gw has LD PRI). Telco won't pass toll-free calls thru LD PRI and customer is using standard route group which is utilizing the 2nd gateway (LD) first then the 1st gw (Local). I c...

To all Cisco gurus,My client currently has Unity 4.0 on 7815 running UM with Domino. They want to upgrade their CallManager to 7.1 but do not want to upgrade their Unity software. Is Unity 4.0 with UM Domino supported to be run with Cisco CallManage...

Hi,I have a 2821 with 6 e1 interfaces. From time to time the e1 from the carrier goes faulty. If your call is routed to the faulty e1 you hear fast busy. Is there a way call manager or the mgcp router can detect multiple failures (fast busy) and shut...

Hello All, I'am trying to configure some translation patterns which translates the 4 digit dialed number to an external number. However when I dial the 4 digits I get a fast busy. the access code is (9.) and normal dialing works.Do I need ro...

Hey,I'm running CME 7.1 (IOS 12.4(22)YB1) with CUE 7.0.2 on a CISCO2821.I made a few changes to our extension numbers over the weekend and now we cannot access our general devlivery mailboxes. Access to Personal Mailboxes has been unaffected.After en...

HI, I have the following issue:The client has some extensions with number:10X and 100X, If I try to dial to ext 1000 or 1002 instead of ringing 1000 or 1002 the call is routed to extensio 100.The same problems with ext 20X, and 200Xthere is a way to ...

Hi,I just installed Cisco Netmanager two weeks back and I have a problem which I suspect might be related to the hardware. the problem I have is that licensing is done according to the mac addresses.Is there a way to transfer the license to the new m...

HiI have a Problem Registering a Cisco SIP Phone (7941).I have done the required configuration for SIP, but the phone keeps saying “registering”When I try to register X-Lite it works fine.Is there something that I am missing??Thanks for your Help...

I have a CM7 cluster in which all GW's are H323. I have a requirement to support a VG224, but I do not want to run mgcp, if at all possible. Has anyone used SCCP to control this? Or is MGCP the best way to do this? thanks

We need to configure some DN on the CUCM to "call" a group of phones. These phones has to activate the speaker so the message can be heared from all interested user.To be more direct I will wrote an expample:- DN 801 will activate speakers on Phone1,...

We have a centralized Call Manager 5.1.2 with four hub sites. The naming convention in our department has changed and we are being asked to standardize the host names for our equipment. We are concerned if there are any "gotcha's" when making such ...

Please refer to the two dial-peers bellow:I ran debug and found out that incoming calls always match dial-peer 911, not dial-peer 1? Users will see caller-id as 911. Could anyone explain to me how dial-peers are matched? I thought it would match the ...

We have a problem with Extension Mobility. When the user logs on the 7970 can make calls to translation pattern *0.[67]XXXXXXX on the partition "disable_calling" and calling search “TARIFADAS”. When the user logs on the 7912 or 7940 cannot make c...