Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
hi all,i have two pri lines terminating on one cisco 2851 router, some time my incoming calls are working fine and some time they dont ..my running config & debugs are in attach doc ??? via debugs info i think and i gets to know that the pri having c...
We configured LDAP at our CUCM 6.13 cluster. However, the corporate directory is not shown as an option under the directories button. The "url directories" under enterprise parameters has the following:http://cucm-ip:8080/ccmcip/xmldirectoryinput.js...
Hi, allWe recently purchased a SIP trunk from an ITSP, our CUCM (cluster of two CUCMs) is behind corp firewall, ITSP only establishes this SIP trunk with one public IP from us, so I configured static mapping on firewall to map our public IP to CUCM-S...
hi,i m using CME 7.1 . i want that only a few user can make an external calls, but all others can only make an internal calls.how i can do that ?thank in advancehicham
Customer wants to block some users PC(IP Communicator)not to register in CME
Hi, dear all!I am trying to register X-lite on CME, but always get 404 Not found error, here is my config:voice service voipallow-connections h323 to h323allow-connections h323 to sipallow-connections sip to h323allow-connections sip to siph323no cal...
Hi,I have intermittent CME MWI issue with the MWI status 'failed' and want to know how to reset the status to able to change to 'subscribed'Advise please,env)-2811 12.4.22.T1-CME7.0.1-CUE7.0.2-CME, sip-ua with CUE IP address, configure 'mwi sip' unde...
Hi, we have 2 setups CME and CM.I need to take one phone from CM and register to CME.I did1. **##** but old CM retain.2. # then 1234... but it didnt ask me to remove old configs. so it re-registered to CM and firmware got updated.3. Erased config (pr...
Does anyone know where I can get full documentation of how to implement the SR140 on a cisco network? I have looked all over the place and cannot find any documentation.Adam
Hi all, We have a psenario having ccme conncted to remote end PBX through sip trunk.I can make voip calls from here to remote.I need a solution to reroute the calls through pstn automaticaly if this voip line is down.If anyone having solution fo...
Hi Guys,I am trying to get some voice translation rules working for incoming calls for one of my clients. This is for incoming international calls, the telco is stripping the leading 00 therefore only presenting the 44 in the case of incoming calls f...
HiI have setup CUCM6, Presence, Unity, Unity Speech to integrate with AD. This was all working fine until rights were removed from the service accounts that Unity uses,and passwords changed. also, we use the unityinstall account on the CUCM, Presence...
Hey, I was wondering did anyone know in Call Manager 6, how to force phones back onto their hunt groups after a user logs off with the Hlog softkey. I know how to do this manually for each phone. But is there a method to do this in a bulk manner? Tha...
Can any one please help. I am looking for a CLI configuration/troubleshhoting command guide/document for the VG224.Any other documentation would also be appreciated.Best regards Phil
Good Morning Netpro'ers :)I'm really hoping someone can solve my dilemma. I have a range of phones that when dialing externally i wish them to use the g729r8 codec. I know how to do this on the gateway under the voip DP with the voice class this is n...
