Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,hope you can help, I have a Callmanager Express 4.2 IPT deployment.The problem is with call transfers.If you try to do a consult transfer and the person you are attempting to transfer to does not answer, you can get the original caller back, but y...
I upgraded publisher to 4-2-3-sr2b. All OK. When I attempt to upgrade subscriber, it fails, and now these errors are all over the application logs of both servers...Event Type: ErrorEvent Source: Cisco CallManagerEvent Category: NoneEvent ID: 3Date...
Hi all,,Iam trying to make a Nokia mobile VPN with cisco 1841 router (has a VPN working config) , but every document said its only work with cisco Concentrators.. but these thing are gone .. so is it work wit only ASA or IOS router also ?and it will...
Dear allI have connected MD110 Ericsson to cisco vocie gateway 2821.the router is also connected via Ethernet to another router the router B is also connected to another PBX(B).the PBX(B) users want to hear PSTN dial tone.but nothing to hear!!Router ...
hello,i have configured the Rightfax server to send fax via h323 gateway, but when i try to test the incoming fax, this last is treated as the sample call, what's tha right conigurtion that i must have at gateway to receive correctlythe fax at the se...
i have changed the default music on hold that is sample audio, by another, but this last cannot be heared by greater than 2 simultaneously.when i configure back the default music, it can be heared normally.Note : this music is provided by cisco and s...
We are considering using an existing call manager 4.2(3)publisher and subscriber in one or our offices as a central site for a remote office. The office currently has a 2621 router that would need to be built out as the gateway router. We are plann...
Looking at an example of routing calls to PRI first then FXO I found the following:dial-peer voice 1000 pots destination pattern 91.......... port 0/0:23 forward-digits 11!dial-peer voice 1001 pots preference 1 destination-patterm 91.......... port 2...
Dear All,We have encountered a strange problem when using Cisco IP communicator 2.1.2.0 with windows VISITA SP1, Call Manager System version is 5.1.3.2000-3.I can hear Voice when making call from the communicator but the other side cannot hearing me...
Hi,we've encountered the following problem:when there are phones in conference and one of the phones is external (like mobile phone) and two are local IP phones on Call Manager. If the external caller drops the call the local ip phones still hear bus...
Hi all,My PSTN phone disconnects after 25 seconds when I put it on hold from my MGCP branch router.I don't know what other information to provide here. Please ask questions.Thanks in advance for helping out.
I'm having trouble getting a B-ACD script setup.Calling the pilot number (1299) generates a fast busy signal.The application script debug shows no output, like the call isnt even starting the script.Heres the config so far:applicationservice csqueue ...
Good MorningI will to implement Cisco IP Telephony in my company. I will to buy 300 ip phones model 7911 and 10 7940. What total cost of implementation with Call Manager and a router serie 2800?Thank you
Hi all, We were experiencing dead air on calls and hence i just went ahead and enabled the sniffer to check whats going on behind the scenes. The sniffer traces revealed there are a lot of out of sequence RTP packet and jitter buffer Delays. What can...
Hi dear,I have two Unified CM 6.0 7835 appliance - one publisher and one subscriber..should i need to activate both server (publisher & Subscriber) or activiting only the publisher will be enough.Info: I received two different licenses.Thanks to help...
