Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi all.We have two CCM 4.3, one publisher and one subscriber.We have a voice gateway, a 2821 router, for pstn connection (with isdn pri).All works well.Problems begin if we need to stop primary ccm: when this happen, outside calls work well, but inbo...
I have a remote site customer with Cisco CM 4.1 and RTMT. They have 3 subscribers and 1 publisher that is runnining RTMT. RTMT is stating that one of the subscribers is down, but it really isn't. I couldn't find any known bugs. Not a good idea to reb...
Unity 4.0(4)Two subscribers are unable to leave messages for other subscribers. There is no error message played to either the caller or called party. The caller hears the called party's greeting and a tone, but no message is left. All other subscrib...
The following error is reported in the backup and restore log 09:00:12 PM] Dumping CDR database on xxx[09:01:24 PM] Database backup verified.[09:01:24 PM] Staging database dump from xxx to staging directory.[09:01:24 PM] Truncating transaction logs ...
dial-peer voice 200voip preference 1 destination-pattern 7… progress_ind setup enable 3 voice-class codec 1 voice-class h323 1 session target ipv4:10.12.0.2 dtmf-relay h245-alphanumeric ip qos dscp cs3 signaling no vaddial-peer voice 201voip pref...
simple right? I know how to modify an existing extension and change it to someone new, but I dont kow how to add one out of the box. Please help...Thanks,David
Hi,Can anyone help me with getting the CDR definition for CCM v 4.3.1.Thanks
CCM 4.1Phone load SCCP41.8-3-3SOne site with multiple phones that will have the phone screens go blank during a call, drop the call and reboot. Some as many as 5-6 times in a few hours. Not all phones at this location are affected. There are only ...
What has been the experience if any that anyone has had with Xmedius boardless fax server solution with CM 4.3 or higher?
I have a 7961G-GE that does not display the corporate directory. What setting do you make for the device so that it shows up?
Hi,Can anyone help i have configured a skinny vg224, and on my voice gateway i keep getting an ephone registering un-registering. The device shows in the vg224 as a AutoCfg_Virtual_Endpoint Oper State: ACTIVE - Cause Code: NONEActive Call Manager: 10...
Hi, I have got a scenario like this..gateway 1 (with 4 fxs ports connected to analogue phones using SCCP)gateway 2 (with 4 fxs ports connected to analogue phones using SCCP).The DDI for the analogue phones(polycoms) matches the DDI range for the 1st ...
Hi,I've a problem with hookflash on my VGs.I have a 4.2sr3 CCM custer.I have been installed the VG224 ( 12.4.T5 ) on my network.I have perceived that when I press the flash key on my analog phones, nothing happens. I still earing the person on the li...
i wanted to know if there is a way meetings can be recorded in meeting place Version: 6.0.171.0.i have this system in place but not sure if i can have calls recorded are there any licensing required or it comes as default, where do i see the licensi...
Hi, I have a Call Manager 6.0.1 and configured at the beginning 3 IP phones. They are registered and have the real phone numbers. Calls to outside und within the network are fine, but calls from outside are rejected (number unknown). I see on the gat...
