Other Collaboration Subjects

Hi,while considering the overall application design for a proxy authentication via EM/AXL, the following question arose: While providing the respective CCM with the proxy application credentials to perform a device login on behalf of another user, yo...

Please let me know if the following are not issues (operator error) or have already been identified. Thanks!!!1.) When a call is initiated and then terminated before the far-end answers the call, 7960 doesn't send ACK in response to 487 Request Termi...

Our call park range is 6X. The problem we are having is that we have a few extensions that begin with 66XXX. So when a call comes in and 66 is the park number, there is a signifcant delay or I have had complaints that they cannot retrieve the call a...

I am in the process of changing a users telephone to check out an issue with calls dropping the problem I am having is that after changing the Mac address of the unit in CM when I plug the unit in instead of booting up I get an error message stating ...

When attempting to bring up a second PRI, and push numbers down that PRI, the calls will route to the CallManager, but the phone will ring once, then go to a fast busy. We cannot find anything wrong with the router configuration, but cannot find any...

Hi I have a 1760V running as an MGCP gateway with a T1 connection to a PBX. The gateway registers with a 3.3 Call Manager. Every so often (weekly), calls will come in to the gateway (verified with 'debug vpm signal') and not complete, there is just ...

We have a paging system and the question was raised if we have a network outage will the paging work. This is at our main site location, so SRST is not set up. Any suggestions to a solution? Currently the paging system line feeds into a VG248.Than...

What is the difference between regular hunt groups and hunt groups on the attendant console?

I have remote users connected to a Centalzed CM cluster using 6608 blades in a Cat6500 for inbound and outbound PSTN calls. Recently these PSTN calls started to breakup. IP Phone to IP Phone between central and remote site do NOT have an issue but P...

Can anyone show me how to open the user options page. I am able to open the Admin page but not the 'CISCO Call manager User Options'.Any Suggestions?Thanks

I have a CCM 4.1 site which is connected to a PABX using an E1 PRI . Calls can happen to and from phones on each system, but when you try and transfer a call from a PABX phone to the CCM system the call gets dropped. Any Idea’s ?Many Thanks

I have recently opened voip account. They have provide me the cisco 7940 phone password.I was able to unlock the phone.After unlocking the phone i have erased the network configuration, when i try to reconfigure it requested to put the password to un...

I am trying to do the Active Directory integration with CCM 4.1.3 with a windows 2003 domain. Every time I go to start the proccess I get "Fail to be authenticated to the Active Direcotry Server to modify schema". I know I am putting in the username ...

We have a callmanager 4.1 and want to know how to configure distinctive rings for phones through callmanager. Can that be done? If so, can it be done in bulk?

We are having problems with Cisco phones 7940,7960, 7970's registering in the 192.168.6.0 subnet it's our voice subnet VLAN 17, usually it registers in the 192.168.5.0 subnet VLAN 9 our Data subnet. We think it has to do with the TFTP server being in...