Routing

1. Does cisco 1811 router supports WAN Failover?2. How will I configure it & also the config of load balancing?

I am having a issue with a WIC-1DSU-T1-V2 on 1841 Cisco Router. I am following guide lines on-line per a WIC-1DSU-T1 (without V2) which is according to cisci.com pdf/page is to be configured with service-module commands rather than controllers but I ...

I have to implement a routing protocol in my network environment how to start as i have 3 routers 20 servers 2 pix and few other routers which are connected to me.Now when ever a clients connects to my network i have to define a route which is the be...

These messages occur repeatedly on a Cisco 877. What do they mean?Apart from POE = power over Ethernet.Is it a hardware fault - returnable to Cisco?Nov 30 12:16:32.948 UTC: esw_dtc_ltc4258_reg_write: no acknowlege from POENov 30 12:16:32.948 UTC: esw...

One of my customers has a 3845 router with 12.3 ISP IOS that has been up for 20 plus weeks.Got a bunch of the following messages and there is nothing on the web to indicate what they mean.Here is the error:bad token 0, wanted TOK_NUMBER|TOK_PUNCTAny ...

this command " redistribute static metric 20 metric-type 1 subnets route-map static-filter" is under our ospf command what does this mean?"

How does the command: "IP dscp ef" works?

Hi, I'm trying to determine what type of network module is installed on a 3660 router in slot 3. When I use the show diag command, I only see the daughter cards on the module and not the part number for the network module itself. Can anyone help? Her...

We are getting ppp authentication failure in a ppp over frame relay setup with a carrier using 2 PVCs. One for voice and one for data. Can you provide a sample configuration?

Hi,I have 4 routers running BGP through megapop circuit.2 Routers from Remote A, which acts as redundancy connecting to Remote B, which got another 2 routers as redundancy also.A new network range 192.168.1.0/24 added at Remote A's Routers. But seems...

Hi,I have two different links from different ISPs, each is terminated on different cisco 2600 routers and used for different services (one for webservices and the other for just internet browsing). However, I want to configure the routers in such a w...

Please, i looking for cost effective material ( router, switch , cable etc...) to prepare ccie RS and ccip.Any suggest 'll be appreciate.

what does redistributing static routes mean? say i have some staic routes configured on the router pointing to my campus network.i have eigrp running on the ATM interface on my router. on this router if i redistribute static routes in eigrp will eigr...

Hi, What is the difference between GRE and IPSEC tunnels? And in which scenarios do we use them?Also, are the Crypto features only on IPSEC Tunnels?Appreciate your responseThanks Navneet

Can somebody tell me the correct way to filter routes from remote sites to a hub site? I have numerous remote sites that have only two or three networks. I want to advertise only those networks to the hub site. I want to filter incoming routes so ...