Activity in Technology and Support
Anyone experiencing blue screens with Cisco Secure Endpoint 8.4.4?
Hi everyone,We recently encountered a blue screen (BSOD) on one of our Windows Server 2016 systems running Cisco Secure Endpoint connector version 8.4.4.30419. At this point, we're not 100% sure if Cisco is the root cause, but the timing aligns with ...
Dialing into CMS Meeting - participant label empty
Hi, im currently struggling to figure out the issue a customer is having. When dialing into a CMS hosted space, in the bottom left corner, the small box that shows the other persons name (or in this case, the space name) is not there. To clarify, i a...
VXLAN and RSPAN between branches
I have vxlan between two branches (configured on the asr1002-x) and I wanted to configure rspan between these branches. Can RSPAN vlan work through vxlan configuraton?
Cisco SG350X-24P shows port flapping
Hi We have a setup where 14 cameras with gigE interface and poe are connected to a cisco SG350X-24P switch.The switch is setup with jumboframes and flowcontrol. The problem is that some of the ports are flapping once in a while. Output from the log i...
Resolved! DHCP addr. required - Guest Wireless
Controller: 9800-80S/W Version: 17.9.5Issue: Wireless guests on open SSID are not getting COADescription: Our wireless infrastructure is made up of 15+ wireless controllers. Right now we have a mix of 9800s, 5520s, 8540s using 2800, 3800, and 9166 ac...
C9300 - Close SNMP Port with ACL
Hi,we have multiple C9300s with public IP addresses. They are running SNMPv3 for monitoring which works but when you do a scan from the internet / outside with nmap / censys / shodan / ... the UDP port 161 for SNMP is responding.We want to make this ...
Etherchannel between Cisco 9300 and two Ruckus (MLAG)
Hello, I want to connect a Cisco 9300 and two Ruckus Core Switches via SFP Fiber. The two Ruckus Switches are configered as MLAG.The Cisco 9300 is configured like this:spanning-tree mode rapid-pvstinterface Port-channel1description UpLink LACPswitchp...
Resolved! Turning VTP off with pruning
Hi,We are planning to disable legacy config of VTPv2 on a network. Pruning is enabled on the domain. When we attempted to run "VTP mode off" on a switch at the edge of the network, we found that the upstream switch appeared to prune all the VLANs fro...
Best practice AP switchport config
I recently moved into the networking role at my company and am looking to streamline the configs that I'm seeing on our switch ports. Since I don't have much prior experience I am looking for guidance on a best practice for what my standard config sh...
Documentation of 9200CX-8UXG
Recently researching ports and configuration on a 9200CX-8UXG. Found a discrepancy in the documentation and product. Cannot open a case as I am not the owner of the gear we are installing. The issue is explained here: switch port identification Hope...
Cisco Catalyst SD-WAN - Manager - Enterprise CA with SCEP
Hi, I would like to automate certificate deployment for our sdwan enviroment. There is an opition Enterprise CA with SCEP, but is this for cedge onboarding or is it only for TLS/SSL Decryption ? Best regards
SDWAN Edge Certificate Renewal
Greetings: Browsing attempting to find the process or procedures to effectively renew edge certificates when they are approaching end life. is there anything close to a scep model that effectively provides a measure of automation. operative word RENE...
Need help with Custom CUIC reports
I am looking for an option where I can get the single report with the following details: Agent Name, Total Inbound and outbound calls, Avg talk time and hold time, login logout activity, reason. For each agent with the above parameters. I see that I ...
FortiGate IPSec RAVPN, Cisco ISE and Cisco DUO
HelloI have FG as internet FW, and We have SSL RAVPN with radius server Cisco ISE and MFA cisco DUO.Now we migrated from SSL to RAVPN IPSec, I tested with ISE, it working normally but when use Cisco DUO I have an issue as below: Event 5400 Authe...
Anyconnect using wrong office 365 credentials
Am logging into a customer's VPN using anyconnect version 4.9.05042The VPN is configured to authenticate / authorize using Office 365 / Azure AD.Anyconnect keeps picking up some saved / cached Office 365 credentials from my machine but they are the w...
| User | Helpful Count |
|---|---|
| 84 | |
| 81 | |
| 78 | |
| 46 | |
| 41 |
