Technology and Support

Puzzling results when pasting in ACL config to switch

Hello, I was creating 2 decently large ACL's to match some traffic today and I noticed something peculiar that has me puzzled. My first ACL has approx 90 ace's and pastes them fine. When I go back and look at the ACL, it looks like there are only lik...

Resolved! ISE 3.2 dot1x authentication with Intune issued certificates

Hi, Requirement is to enable dot1x wired authentication/authorization for Intune registered devices. There is only Azure AD and Intune. There is NO On premise component (no on premise/traditional AD, or ADCS) According to the following link, we need ...

AP-AIR2802i-B-K9 No join

l installed newest version of Wireless controller 9800-CL Cloud but wont Join DTLS Error l dont why it wont join to controller

Configuring NAT overload with vrf lite on a CAT9K

Good day;Need help with how I can configure NAT overload with an existing vrf on a CAT9K_IOSXE V16.12. This is what I am struggling with, I currently have a vrf called AWSDX-S3. Now what I am trying to do is I have added a L2 SW and ran trunk ports...

Wired Guest issues in foreign-acnhor setup

Wired guests are not able to get out to internet, they can ping only at when payload is set to 1300 bytes or lower, this seems like an MTU issue, but its only effecting wired guest not wireless guest. Setup is a 9800 foreign on 17.9.5 code and 5520 a...

3905 Line 2

Is it possible to make a 3905 have a second line?

Profiling Wired Endpoints without 802.1x or MAB using IBNS2.0

The configuration below is an IBNS2.0-based config that puts all access-mode switch interfaces into an authorized state, with no MAB or 802.1x needed, to pull device-sensor information and ship it to ISE for profiling unintrusively. It is a nice...

Disable SIP ALG on Firepower 1010 by Web or Telenet

Hey allI have a Firepower 1010, I need to disable the SIP ALG on it, I have access to the Web Client and Telenet access to make changes, can someone give me an easy way to make these changes, I don't have the ASA Software that could access with.

Risport70 selectCMDeviceExt does not return CTI Port status

I am trying to retrieve the registration status of phones and CTI ports on CUCM using Python. To do this I am first running the CUCM AXL query listPhone to get a list of all phones I'm interested in. Then I pass this list to the SelectCmDeviceExt RIS...

FTD intervlan questioning,

Scenario,Host-A(10.10.30.3/24) connects to access port on SwitchA with various other vlans also configured via access ports. SwitchA connects on a Trunk port to a CatSwitch. Firepower inside ½ interface trunks to CatSwitch. On The CatSwitch 3 vlans; ...

CGN problems on ASR1002HX (with banks)

Hi Community!I've some problems with one ASR1002HXI have several deployments in different cities, but with only one, the sessions in some home banking get closed after some minutes. It's not exact, sometimes after 1 minute, other after 4 minutes (alw...

[EDIT] How to retrieve the portal ID of a guest account?

We have two ISE ecosystems different and isolated (2.7 and 3.2)I must migrate guest accounts from one system to the other one.On 2.7 we have two sponsorportals and so it is on 3.2.I managed to retrieve captive portal users through a python script of ...

Unsolicited CALL-HOME-DETAIL and CALL-HOME-TRACE messages

Greetings,I have a Catalyst 3650 (IOS-XE 16.9.4) that is sending a ton of unsolicited messages to the console. These don't look like Syslog messages. Can anyone tell me how to get this to stop? The switch has been cleared (del vlan.dat, wri era, relo...

vManage SDWAN PCAP scripting help.

Good morning all!I am working on a project on our SD-WAN. I am new to SDWAN and vManage and was asked to look into possibly scripting some packet captures over a period of time. Our SDWAN consists of several IR1101's and they can only be managed via ...

Multi san callmanger certificate private key distribution

Hello, Apologies for how late this question is! I have read that it is possible to generate a multi san certificate for the call manager service. Each subscriber in the cluster then uses the same certificate for call manager service. If I generate a...

Technology and Support

Browse the Community

Certified Remanufactured Equipment

Cisco Software

Cisco Start

Collaboration

DevNet Hub

Data Center and Cloud

Internet of Things (IoT)

Networking

Online Tools and Resources

Security

Service Providers

Services

Small Business Support Community

Wireless - Mobility