Hello Cisco ISE lover, Currently, I have an inquiry refer to posture process. As we have Pending and Complaint status for DOT1x (Supplicant) wired connection. Base on your experience, does Posture process will cause/delay/slow for window PC logon pro...
Bonjour, Je me demandais si le modèle AXE pouvait supporter 2 antennes patch avec 4 ports ? Sinon le modèle stadium ?Je n'arrive pas à trouver un AP Cisco récent qui fasse l'affaire. Merci d'avance !
Hello, everyone! I am currently studying DMVPN Phase 1 and I have a question about the following command: ip nhrp map multicast dynamic I understand that this is issued on the hub router/the NRHP server, but what exactly does it do? I was a little co...
Trying to join my first AP which will the the primary AP. During the boot process the I am able to almost Go Live using the Cisco Business app but after creating the management SSID and the device reboots it gives error message that it cannot find th...
Hello AllWe are running flexconnect wifi and using the same ssid across multiple sites.We want to deploy a splash page at each flexconnect remote site for one of our ssid's We do not want to deploy all sites at the same timeSo is it possible to authe...
Is there any way to SSH into the CML labs? I have tried using the external connector, but cannot connect to the IP address received over DHCP. Any tips on direct connection? Also, is it possible to connect directly to a console port, rather than u...
This is a bit of a weird one We have a large core rtr (Layer 3) doing all the Routing across our VLANS. We came into a situation where we lost core recently witch then meant that one of our vlans that has storage for a specific system went down badly...
Hi All,I would like to know if it’s possible to create different posture policies for wired and wireless endpoints. For example, since wireless users typically use laptops and are roaming clients, the Cisco Umbrella service must be checked. However, ...
Hello everyone,I face following problem, maybe some ideas to help?I have Room Bar Pro + Navigator + to external Ethernet Microphones (CS-MIC-ARRAY-T) connected directly to the Room Bar Pro. System was installed few month ago, and worked correctly, bu...
Hii guys,Need your advices, My devices is cisco NCS5500 series with dual routing processors and will upgrade from version 7.x.x to 24.x.x. Can I upgrade from standby RP first, and then swing the RP? Or just upgrade the active RP one, then the backup ...
Hi All, I have IP SEC tunnel from hsrp peer1 and dna advantage license activated on it and peer2 activated with right to use (RTU).Ill setup IP sla from peer2 towards peer 1 and will be tracked by EEPM applet.If Peer 1 goes down, then EEPM applet wil...
Is there any way to go back from C3PL to legacy style? Is write erase, reload with backup config only method? Wanted to test config for few ports but i completly ignored the message clearly shown on CLI and copy and pasted a whole bunch of class poli...
I need to work with mohAudioFiles as part of an extension of an application from my team. So I added support for the class in my own AXL lib, and when I went to check the required parameters for an add, found there's no addMohAudioSource method - jus...
