TelePresence and Video Infrastructure

Hi All, Is it possible to configure an SX80 for H323 IP to IP dialing and have it registered to CUCM for voice calls via SIP. I assume this cannot be done using native registration but what about as an 3rd Party SIP device? Any info would be appreci...

Can anyone recommend an active sound bar, that does not use a subwoofer, that has the frequency response to work with Proximity?  Or a line of TV's they've had luck with?  Nearly everything stops at 20kHz.

When is the End of Life for the EX90, and what is the recommended hardware upgrade solution? What is the recommended hardware upgrade solution from Cisco on the TelePresence Profile 52/55 C40? Thank you kindly in advance!!

Hello, We have setup a single C server and single E server.  Both servers have a single LAN interface configured.  Single subnet DMZ. We are able to successfully register a phone but there is no audio in both directions.  We have reviewed our firew...

Hi, We are currently facing an issue where content is delivered extremely blurry. We are presenting from codecs (C40, SX20) and receiving on a range of codecs (C40, SX10, SX20) & Jabber it doesn't seem to matter what we receive it on. I have tried di...

Hi All, Is there a way to retrieve the username and password for both webGUI and CLI without doing the factory reset of the codec? because we do not have any backup configuration of the codec so it is not possible for us to factory reset it. Appreci...

So...On TC7xx our codecs were configured with SIP Listen Port "off" and Outbound Mode "on". With the realease of CE8 Cisco removed the option to configure outbound mode. So now all our codecs running on CE8 platform gives the warning: "WARNING: SIP L...

Hi,I have a problem on my TCS server, a message is displayed "The overview for this server can not be found"This error message appears when I last reinstalling the usb image provided by Cisco,Thank'sBillel

I need to connect a Crestron MC3 to a SX-10 and monitor codec wake/sleep.  No RS-232 port . . . how do I connect.  I do not believe the Codec and MC3 will be on the same network so IP control is out.  How do I get there? thanks.  

Dear Cisco, I have 1 unit of cisco sx20 and 2 units of cisco sx10 all in standalone mode, when i call to other site with cisco sx20 on H323, the calls are fine. but when having a conf call with SX10 units on SIP protocal, the call is disconnecting e...

Hi, I have a Cisco Telepresence Sx20 and I need to connect through public Ip address.  I would like to know if is possible to connect through Laptop or smartphone using app like proximity.

all, is it possible to disable the 10" touch device and use the standard remote control such as the TRC5 or TRC6 instead to operate the system on the SX80 with ce 8.2.1 installed ? rgdsAndy

Hi Community, We are testing outbound B2B calls and found out this SIP URI addresses for testing: loopback@rtp.ciscotac.net loopback2@cisco.com The network admin needs to know the specific IP addresses that need to allow on the firewall to reach the...