I'm currently working from home, and my older laptop bit the dust this morning. I set up my newer Dell Alienware, and all was good. I'm using the same headset as always, I can hear everything fine (including ring tones), except call audio. People can...
Forum Posts
Hello,I have a cisco callmanager express and the SIP provider gives us the following range number to be used to make outside calls. the range is from 555091900 to 555091999.These numbers are configured on users IPhones as an extension for making outs...
Hi everyone,Do you have any ideas why i can't pair my SX20 system with proximity on my pc ? the proximity software is running but don't find anythingI found it weird because it work perfectly fine with my other systeme which are webex room kit and MX...
while not sharing the screen in a webex meeting and trying to make it full screen it enlarged, but still fell significantly short of a full screen.
Hello,We have a semi-new 12.5 CUCM setup. I am currently experiencing the "License Authorization Status: Failed". on the Unity Connection servers only. When I run "Utils Diagnose Test" I get the reverse DNS lookup mismatch error. The entries in DNS a...
Hello there, We have CUCM version 10.5 and using Jabber clients for Android and iPhone. The problem is that when calling from user A to user B - which is using Jabber Client for iPhone, call connects, there is 2 way audio, but when B is transferring ...
I am curious about integrating Active Directory with CUCM (12.5) and Unity. Currently Unity mailboxes are populated with AD usernames as the aliases. Most CUCM usernames are AD usernames. If I were to integrate AD with CUCM, what would happen to t...
Resolved! Upgrading CUCM from 10.5 to 12.5
Hello all, I need you help to upgrade our CUCM 10.5 to the latest version 12.5. is there any road map? how can I start to do that?here is a table and specification we have for our CUCM system. SnDescription Current Version Upgrade Version 1Cisco Unif...
Hi all,Have anyone successfully enable Cisco Cloud Onboarding (for APNS) on CUCM 12.5(1)SU3 which has Smart Licensing with on-Prem Satellite server? Any tricks?If I set the CUCM Smart Licensing Transport Settings to "Direct", I can enable Cisco Clou...
is it possible to block all inbound PSTN calls for a specific user?the closest solution was to block a specific PSTN number (and repeat same for other marketing callers) ... but that's not sustainable anymore.
Hello,We have a 02 VCS (Video communication Servers) with each a "40 non travesal calls and 100 traversal calls" licence. We would like to replace these VCS licences with a new CUCM, but we would like to benefit from these purchased licences in the ...
Hi, is there a way to make a list of empty device pools in CUCM? Same question applies on other configuration parts like regions, locations...We have a complicated setup with more than 300 device pools/regions/locations, also have many other configur...
Hi, we have MediaSense using as VoH for years, but now after upgrading CUCM to 12.5 SU3 we have issue with it.We cannot access any administration settings. Eg. on Unified CM Configuration there is displayed error:"Error reading Available Service Prov...
I am planning to change the existing setup (CME 8.5) in our company... we got 2900 router with cme 10.5 , need to configure the CMC in this router to place the international calls. i checked everywhere but couldn't find any helpful docs to configure....
Hi Community, I'm having this weird behavior with my CUBE (csr100v) For an active call, when searching with the following command, i get nothing as the output, as you can see here: hq-vcube1#show call active voice brief | i pid<ID>: <CallID> <start...
