Hi Friends,I am getting an error message when i connect new cisco phone to the network. I am using UC560. is it license issue or any configuration issue. CCA-->CONFIGURE--> SYSTEM-->system setting, where i can find that License su...
Dear All;I would like to install cucm 9.1 on MCS SERVER - MCS-7825 -H2. I can upgrade RAM and HDD if required. Is there any way to install ? according to cisco matrix sheet it is supported upto cucm 8.6 but some of engineers which i have links they a...
Hello.We have a production environment with one publisher and two subscriber, all of these running 6.1.5 release.All was ok until last friday, when we have tried to ugrade publisher to release 9.1.2 and it has failed.So, we have performed a reinstall...
Hi all,I am using call manager 8.5.1 and Unity connection 8.6.1 Do we need to purchase a software to upgrade to ver 9. Any steps to upgrade from 8.5 to 9 for both CM & CU
So, my phone template that I used to BAT in my phones has EM enabled on it. I need to set Owner ID, so I wanted to use BAT to disable all of them at once (to be re-enabled when I am done). When I go into Update Phones, I see the 2 check boxes to the ...
i have a hunt pilot number hivch is 5000 and under this hunt pilot there is 15 member with extension starting from 4001 to 4016. The customer want to have the following:1- all the phones rings at the same time.2- if nobody pick up the phone the calle...
Hello,I have been searching for a way to automatically reboot the Cisco MCS 7800 Series. When we have a power outage I need to go onsite to restart our 7800 to get our phones back up. I wanted to see if there is a way to have this start on its own af...
Hi We are Using Jabber along with Outlook Version 2010problem is Presence status is not updating in Outlook .. we can't see Green /busy status in Outlook resulting not able to dial Jabber users from Outlook .. Can someone pls assist ..Re-insta...
Hi,we are planning to migrate from cucm 6.1 to 8.6 in vmware.My question is, how do you port dlu from 6.1 to 8.6 ?Just ask licensing@cisco.com to rehoming dlu in virtual mac address?And which product code should I buy for the 8 cm software?If instead...
Hi!We recently migrated from Unity to CUC v9.x and notice that some of our VM messages with Single Inbox are going to user's Junk Mail folders in Outlook 2010.We attempted to add the sender to a trusted list, but because the address is "user@unityser...
Hi all we have 2 Call Manager 7.1.2.31900-1 boxes. Recently we had a power outage and the servers were not shut down properly. One remaining issue we are having trouble resolving is this error below. It appears in the logs every 15 seconds or so. Any...
I'm having an issue I'm hoping someone can help me with. We have an executive assistant that answers calls for extension 1111. If she is unable to answer the line (whether she is using her phone or not), 5 other people should have the ability to answ...
Hello All,3 FXS cards are seated in 3845 cisco router. 1) EVM-HD-8FXS 2) EM3-HDA-8FXS 3) EM3-HDA-8FXS. In voice gateway the voice ports are displaying from 1/0/0-1/0/23 but in CUCM the ports are displaying as1/0/0-1/0/7 (EVM-HD-8FXS)1/0/8-1/0/15 (E...
