Hello Folks, I met a strange setup for a LAN Cloud in UCS Manager (3.2.3k) There is a production VLAN with the same name and the same ID, which has been definied both in "Dual Mode", and also in "Fabric A" in the LAN Cloud (don't ask why ) - What wi...
I'm getting no where trying to get this server up and running because I can't find a way to allocate the RAID groups to the locally installed SSD disks.The server has the following disks in the following order:DiskSize (GB)196029603960496059606960796...
Hi, We are experiencing issues with upgrading our individual standard-mount rack blade UCS servers. We know of an interface on their Hyperflex that allows remote upgrades of UCS servers. Could someone provide any documentation with procedures for a s...
Not clear how this can be fixed for KVM console opened from CIMC
how we can migrate boot from SAN to Nvme on Cisco UCS B200 M4 (because we are planning to upgrade to esxi 7)
Hello, We are planning to replace the old fabric interconnects in our customer's data center. The plan is to buy new FIs but to keep the old chassics. According to the datasheet, the IOM module won't be a problem because the 6454 FI supports both Cis...
I'm in the process of planning a migration of a pair of 6296's to 64108s and am trying to clarify a few points from the migration guide that Cisco has published for this process.The intention with the hardware upgrade process will be to:put the Sub. ...
Dear All,After upgrading UCS C220M3 firmware from 2.x to Version: 3.0(4s), i am facing wierd issue. When i try to open the CIMC IP address, the page is getting opened, but not able to find the username and password field to enter.Moreover in the brow...
We are using NSX-T Transport Profiles to map ESXi vmnics to the NVDS (NSX-T) distributed switch by name. So vmnic2 & vmnic5 in ESXi are automatically mapped to the NSX-T dvSwitch.Problem:I have a UCS Service Template setup with the following vNIC set...
Hello,I recently was tasked with recovering/fixing a lab UCS system. The intent is to install ESXi. The chassis is not functioning correctly for multiple reasons. I have a lot of questions and not sure how to get direct questions for the particular s...
I am trying to get the Rails for 2 C-240 servers removed from a rack but cannot figure out how to get them to release. I have remove the servers and the rail slide but don't see how to release the locking plates in front and back.Any ideas?
Hi, i have just upgraded our pre-prod environment infrastructure to 4.1(3h), and am about to start upgrading the hosts. we use vmware 7.0U2c - but wanting to go to 7.u3 as soon as we can, so i wonder which drivers i need to be installing on the h...
Hi all,i just did an upgrade from IMC Supervisor, installed Version 2.3.2.0 to Release 2.3.4.0The Patch installation went smooth.Now, i had to discover and import a new Server within an area which was already having an existing Discovery profile.So, ...
Hi, I have a hyperflex cluster of three nodes with 2 x FIs. The VIC ports from the servers are connected to the Fabric Interconnects.I would like to use the two embedded (on the motherboard) Intel i350 GbE Ethernet ports but cannot see the hardware f...
I am trying to use SNMP to get the current status of san-port-channel from UCS FI 6248UP but I am not able to find matching OID.The FI works in End-Host-Mode and san port channel consists of 2 ports (TNP on FI side and TF on MDS connected to it). The...
.jpg "VIP Community Legend"){kind=icon}
