Wireless

Hi, I have configured WLC2504 "Maximum Allowed Clients Per AP Radio" set to 30 clients limit but still APs are connected with more then 30 clients. Enclosed screenshot for the same. Kindly help me if I configure this settings wrong. Regards Rajind...

hi i am trying to follow the official hyper v guide shared here http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-4/b_Cisco_vWLC_on_Microsoft_Hyper-V_Deployment_Guide.html and demonstrated here Video demonstration of how to deploy...

Hi  i am trying to install Cisco Virtual Wireless Controller on vmware workstation please can any body help me out .  Thanks 

Dear Gents, I have 5508 WLC running 8.0 SW, multiple SSIDs are configured and each is mapped to a certain VLAN on the network. I'd like to block certain MAC from connecting to certain SSID on the WLC, using MAC filter doesn't help as it's allow list...

Dear community, we plan to replace our 2 old active WiSM2 WLCs (no HA - both active) to replace by 2 new 8540 WLCs. In the new enviroment we plan to run the 2 WLCs in the HA mode. What would be the best way to go ? Would the following way be fine ? ...

Hi, I have a doubt about the understanding of the uplink throughput of WLCs. What's the goal to have for example 8 Gbps throughput on the 5508 (so, 8 ports used) if the AP's (2702 for example) can only reach 1 Gbps ? Thank you,

Hello, Users started to complained from disconnections. i have logged one of the AP and found below logs: *Aug 2 17:34:25.199: %DOT11-4-FLUSH_DEAUTH: Consecutive tx fail 500+: deauth f859.710c.75fb*Aug 2 17:38:14.323: %DOT11-4-FLUSH_DEAUTH: Consecu...

Is there an expected time frame for the next release in the 8.0 train?

Hola!! Tengo 1 ssid con seguridad WEP en una controladora 5520 con aps 2802. Pero el ssid WEP  NO se publica, no se ve en mis opciones de redes a conectarse. Alguna idea de porque? wlc version:  8.2.151.0 ap: AIR-AP2802E-A-K9 Saludos!!

Hi, We have 8540 WLC controller and AP model is 2702. We observed After rebooting APs, Aps loses its configuration like Nme and VLAN assignment. IS some one has any clue on this please suggest. . .Controller software is 8.2.130 Thanks Rohit 

Hi, does anyone know how to assign a dedicated management VLAN other than BVI1/VLAN1 to a Cisco 2700 series IOS access point? At the moment we are using the default BVI1, which maps to VLAN1: interface BVI1 ip address 192.168.0.1 255.255.255.0 no ip...

Hi , I need how to configure native VLAN ID in wireless controller in gui and cli and how we know assigned vlan id in client page. Thanks, Basavaraj

Bonjour la communauté, Mon problème est le suivant :Je recherche désespérément un mode d'emploi sur la configuration de six bornes Cisco. Les six auront le même SSID. En sachant qu'un serveur DHCP existe déjà. Et que lorsque je n'active pas la foncti...