Wireless

I am using WLC 2504 with AP1242 to access LAN through wi-fi and below are the details/configuration i am using. 1. Using a belkin router with LAN IP 192.16.17.50 and DHCP 192.168.6.12. Connected WLC 2504 with belkin router [192.168.6.254] and enabled...

Hi Guys,In the process of implementing a Virtual WLC. Just want to find out about FlexConnect Local authentication process. My question is am I able to configure FlexConnect groups to send client athentication (PEAP Authentication) requests to a loca...

 Hi all,When we try to connect any windows mobile to wlc (code-7.2.103.0), it doesnt connect and stay in '802.1X REQD' status. What could be the issue.?SSID settings WPA+WPA2, AES, 802.1X security.MFP is "optional" I have also attached the debug logs...

Hi,Internal DHCP server is not supported for WLCs configured in 1:1 HA till release 7.5.Is internal DHCP server supported in release 7.6 as I didnt find any such limitation in release notes as mentioned in release notes of 7.5?

DHCP Proxy is required in order to use local WLC DHCP Pool (Guest Anchor), however reading Wireless Q&A (http://www.cisco.com/image/gif/paws/107458/wga-faq.pdf) states that both foreign and guest anchors must have :In a Wireless guest access setup, t...

Hi Team, I have  following BOM Cisco Prime Infrastructure R-PI-1.2-K9Cisco Prime Infrastructure 1.21R-PI-1.1-500-K9Prime Infrastructure 1.2 Software - 500 Device Base Lic1L-PILMS42-500Prime Infrastructure LMS 4.2 - 500 Device Base Lic1L-PINCS12-500Pr...

 Dears , i have APs 3700 I,E,P models  and added them successfully to WISM ver 7.6.100  . but when i added the controller to Prime infrastructure ver 2.0  it does not show any access point !!!!!  AP Count = zero . so does PI ver 2.0 supporting the ne...

Hello,on the web interface, there is an error indicated for the transmitter power.I have no idea whats wrong.The follwing supported dual band Cisco Antenna's are in use.AIR-ANT2524DW-R= Here is my config:!! Last configuration change at 23:21:26 +0100...

Hai,I have 8510 WLC and outdoor AP AIR-CAP1552E-M-K9   .I am using the country code SA.All APs are associated to WLC. a/n radio & b/g/n is showing UP.But my AP  is registered in Bridge mode. When I put the AP in local mode, Its a/n radio is  going do...

Good MorningActually I have some AP`s (1130) in my central office and other in remote office. I use a wireless device called Handheld (Motorola) to download an archive .cab but when I try to do this from server located to central office, it get to in...

Hello there.I'm about to roll out a WLAN setup for a Warehouse with 7.5m high ceiling and full-height racks for stocking different kind of items (the exact nature is unknown to me).I was thinking about deploying 1600 Series APs but I'm not sure wheth...