Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi, Everybody have the procedure to configure a Cisco CP-3905 in asterisk server?The CP-3905 is compatible with this servers?Thanks
Dear Networkers,Can you please help me with the capacities for video conference capacities for PVDM3 DSPs ?I checked the documents in the link below and found the following table. What I would like to know is how many videoconference can a PVDM3 card...
Hi AllCould u please help me with 7941 phones, They are gving error after booting.below errors are blinking one after anotherError: Registring,Configuring CM list,updating CTLI tried factory reset with Soft reset(123456789*0#),Total hard reset(349167...
Hi,I have a Cisco IP telephony solution with 1x cucm Publisher (v8.5) and 2 subscribers. I need to add another box and set it up to act as the failover cucm for the publisher. Can this be done? If so any thought how to set it up?I dont need a 3rd sub...
Hello,This may be seen as a very basic question but is it possible on a per User basis (9971/7965) running Call Manager 8.5 to translate an inbound number eg 90791234567 into Blogs, Joe (Mobile) on the screen display? I guess if you used LDAP and di...
I have a customer who asked me for a speciacl request. The customer has 4 FXO on his gateway and his gateway is registered on CUCM.The customer asked me to define a FXO port from the four ports to him only ( he can do outgoing and incoming calls from...
Hello All,I have callmanager 7.0i have configured speed dial button on phone A to monitor phone BWhen phone B get connected in a call, the BLF button onphone A shows the busy icon.BUT when phone B is ringing the BLF button on phone A do not blink, i ...
Hello,I have a user that says her fingers are to fast and she want to turn off auto complete. She says auto complete is causing her to mis-dial. She has dialed 911 on more than a few occasions. Her example was 9191xxx, 91 to get outside and long d...
Hi,Anyone knows what culmapsvr process on CUCMBE 7.1 is?
I have a Cisco Business Edition. I have been some testing with it previously, but now it is time to get it configured for a client. How do I factory reset this device so I can configure it with the specifications of the client?Thanks
Making simple forwarding change to a user, saving and applying config. I move to a new screen or two come back to the change I made and its gone. I can duplicate this over and over. Has always worked just fine. Where do I begin to look ?
have problems accessing the CUCM Express 9.1 by web. What can be the problem ??Thank alot !
According to the this document: http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00803f818a.shtml#configs you can assign inbound and outbound translation-profiles to trunk groups, but it doesn't seem to work as adver...
Hello,can anyone point me to a hardware compatibility Matrix for CUC that lists all the versions? I want to make sure we upgrade to the highest possible revision support on the servers we have.Thanks. Replies rated.
Hello,We are facing a weird issue where our CUCM Publisher cannot boot up. I have already tried to repair the system through the Recovery Disk with no success.Find below the system messages:"Booting command-list root (hd0,0) Filesystem type is ext2f...
