hi! i;m using cm7 with cisco unity express. how do i set the changes in the main line directory. eg those options that you normally hear when you call the main line, that allow you to press certain number to go to certain dept/directory? I would like...
Hi friends,I´ve never configured the conference call on CME, so i have some doubts :1-) I will buy the IP Conference Station 7937, how many participants are possible simultaneously ?2-) Do I have to configure special configuration to conference? If ...
I am attempting to upgrade from CUCM 7.1(5) to 8.6 while also migrating from MCS to UCS Servers.The prefered order of operation:1. Setup UCS Virtual Machine with CUCM 7.1(5)2. Restore from 7.1(5) MCS Backup to the 7.1(5) UCS VM <------------(Recievin...
Hello all,I have the request for simultaneous ringing while using a CME v 7.0, however the following configuration doesnt work:!voice hunt-group 2 parallel final 3201 list 3201,85201,5201 pilot 5201 !What we want is when someone calls 5201 to ring si...
I enable multicast on one of the MOH server in CUCM and added this server in Media resource group assigned this group to devicepool.CME SRST Router configuration,dial-peer voice 70 potsdescription MoHdestination-pattern 7000port 0/...
Hello,I recently upgraded the SCCP firmware of my 7970G phone to the latest version 9.2(3). I am not using CUCM for the time being, as I use it at my home with elastix, so I upgraded the firmware using a TFTP server. The problem is that since firmwar...
Hi,I have adoubt about the bind interface.Im having problems setting a SIP TRUNK, Im guessing everything because the SIP SP is not much helpfull.My question is because when I put sip bind all source-interface Loopback0 /* lo 0 is the same source-a...
I am having some call center agents saying that they see an inbound call on their software of their call distribution provider. But they say their phone is not ringing. Can someone provide some trouble-shooting tips to verify whether the phone rang...
Any thoughts on the DMA modExportDatabase=Failure error[09:28:20 AM] Validating exported Cisco CallManager database and directory data. [09:28:20 AM] This can take a long time, depending on the size of the database and directory. Be patient. [09:28:2...
Hi all,I'm having couple of issues with the analog trunks. 1. Calls getting disconnected after one ring when we dial outside ( This is happening only intermittently)2. Although customer has six analog lines, they coudn't dial outside after 2nd call (...
In CME 8.6, non-office hours end users call should be forward to the mobile number. In Holidays all the calls should be forwared to remote destination, In CME 8.6 it is poosible call routing based on time and Holiday ?
Hi I have a bit of a complexed design.Call manager 6 is configured as centralised with gateways at mutiple sites. Some sites have extensions of the call managers using voip phones while other sites that already have their pbx connect to the call mana...
Hi All,I am currently facing an issue where i have conflicting numbers in my dial plan and i need to find a solution to it immediately.I have internal extensions that starts with 108X and i also have a route pattern that is 108XX that goes to my pagi...
