Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Do we have any known issues with CUCM 7.1.3...while CFAll to any PSTN number?The setup is a migration from 4.1.3 to 7.1.3TIA..-Amit
Hi all,Now, I want to migrate my CISCO CME to the CISCO CCM 7.1. Is it possible to use the existing IP phone set license ? So, I don't need to extra license for these phone set.ThanksLeung CHe Man
Hi all.I have a problem where the fxs ports in a VG224 just disapeared.I can not configure a voice port any more. tried removing the VG224 from CUCM and adding it again doesn't work.some show commands below.Any idea to what could be the problem.Thank...
I have been browsing through the posts and found a few that talk about the originating caller ID not being displayed on calls coming in from the PSTN destined to the IP Phone and then forwarded onwards to another PSTN destination like a mobile phone....
How can I delete the default background on the 7965\7945 phones? We have uploaded a new corporate image and its the only pic in the list.xml file but the phone shows the default and the new background image. We need to remove the default so the only...
Due to rapid expansion, a customer has run out of extensions and voicemail boxes on the Primary CME (3845 CME v7) with T1 / ISDN PRI. The DID blocks (there are 4 different blocks) are connected to the 3845 router.We have setup a 2811 CME v7 (No T1 ca...
Hi all,Could you tell me what is the latest version of CISCO Unity ? Also, how many component and devices I want to buy for about 70 voice mail?ThanksLeung Che Man
Hiii,Is there are any handy application can be found in the internet in addtions to SDK 4.1.Thanks..
Hi just purchased a 7915 Expansion module for a Cisco 7971 phone for our front office receptionist. I've done some reading and I'm a little confused about the firmware loads. We are using CME version 7.1. The current phone load for the 7971 is "load ...
Hello Floks,We just upgraded from CUCM version 6.1.1.2110-1 to 6.1.3-1107-1 .Small number of our phones have reverted to an earlier configuration following the upgrade (for example displaying an old name on the display). IP Communicator profile ...
Hi All,I am having this issue with a cisco 3825 router with cme 4.0 and cue 3.0.The system and hardware clocks are both correct as well as the cue time however the times on the ip phones are 4hrs ahead.I have attached the "sh run" file.The logging se...
I just installed several phones at four different locations. Whenever a user gets a phone call, the Caller ID displayed on the screen does NOT show the first character of the caller's name.Two examples:A call from John Doe is displayed as "ohn Doe" ...
a user is not grtting to voice mail ,he logins from the phone and he is redirected to main menu instead of voicemail box ,he can store and get voice mail to he outlook please provide me asolution to thisThank you
Hi all:I'm having problems with my CIPC 7.0.2. I was using it on my CCM, as usual, but then I needed to change it to another CCM for testing. I had to erase config from CIPC. Once I came back to my CCM, it registers, but it does not take all the conf...
Hello,I have a question, is there a way to centralize voicemail with CUE, what i mean is we have 3 sites all running CCME version 7. the customer would like to have centralized voicemail, the main site has CUE & CME. is this possible ?thanks
