Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi Everyone,I just finished a Call Manager upgrade for customer from 4.1.3 to 7.1.2. As a part of the upgrade, we also upgraded their H.323 Gateway from 2651XM running 12.3 to a 2811 running 12.4.25b.After the gateway upgrade faxing stopped working. ...
Hi,I'm trying to regsiter Avaya 46XX series IP phone the CUCM 6.1(2), over SIP.I do have SIP enabled image with me for Avaya.Need advice,1) Is this doable or possible to register Avaya IP phone as 3rd Party IP phone?2) If answer is yes, then please d...
Hi, MOH is not working when I place a call on hold and also during transfers. Checked in the Media Resources and the config seems to be working fine. Is there anywhere that I need to check apart from Media Resources. I have a Call Manager 6.1(2) ...
How can register remote ip phone(7242G) over the internet?Besides ASA phone proxy, cisco 2800 series router's ios can do it with TRP(Trust Relay Points)?
Anyone know if/when Cisco UC products will be supported on these platforms?Would be nice if it was in UC8 in Q1 2010.
is there a way to have internal extensions show as their external DIDs when forwarding calls via mobility? I setup external masks on all extensions but they still come through as 4 digits. If i do a prefix digits on the route list, that would affect ...
I have approximately 100 of the original CP-7960 handsets (not the 7960G model) and am wondering if they are compatible with CUCM 7.x?The compatability matrix shows the 7960Gs as compatible but no mention of the older 7960 model. These were the origi...
Hello,i have installed right fax, and i want to have all the steps to configure it and to integrate it with exchange.How can i do that ?Please help me.thnaks at advance.
I would like to get the communities feed back on this issue. Certain users within our company (mostly linked to 800 numbers) continue to receive dead air phone calls. Is there a standard way of dealing with these calls? I know that with an H323 envir...
I have a user that is claiming she doesnt have "transfer" as a softkey option. I have the same softkey template as her and mine is there 100% of the time.She says that hers isnt there sometimes when she is connected. it happens more often when she is...
We are running unity connection 7.0 on the lab and trying to integration with exchange 2003. We have run into a problem with MWI not coming. When a message is received the MWI light does not come. I clicked a run button synchronize MWIs manually on t...
Doing patches for a CUCM 6.1.2.1000-13 wondering if update 6.1.4.2190-3 will resolve the daylight savings issue for the legacy ip sets not updating their time with the new DST standards. Thank you
Hi All, when someone parks the call, the call revert back to operator. how can I configure to revert back to originator who parks the call not operator? thanksAlex
Hi,We are using 7911 IP Phones,we want to do the Logical Partitioning so that we can use this phone for PSTN & VOIP calls.Can we get good document regarding this!!!!Regards,
please light me 7815I2 will support 7.1 upgrade
