Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I have a Network with two GW`s one of which doubles as a Gatekeeper. Connected to GWA is a CCM and connected to GW B is a TDM system, if I route via the two GW`s uisng H323 direclty then the call rings and connects OK however if I route via the ...
What is the maximum number of direct lines that can be configured on an E1. When I try to configure translation rules, it does not take more than the 15th translation. Please help.
I am having issues with one of our client. We have some analog lines mapped with same number and terminated on voice gateway. When somebody calls from outside the Operator phone rings but it gets dropped as soon as it is answered and the strange thin...
How can I change on a 7911 the default Monitor softkey to the Listen Group softkey?
Hi I've configured Call Block to any mobile number, by means of the prefix that needs to be dialed to place calls to mobile numbers. Problem is that some users need to be able to call their Supervisor on their mobile number. How can we override the b...
cane we integrate CCME 7.1 with Cisco Unity 5.x for Auto Attendant only without utilizing any License ?????If yes can any one share the guide ??Reply urgently Thanks in advance
Is there any way to integrate Lotus Domino system and CCM 6.1?
I have 2 x 7921G phones. Phones make wireless connection, draw IP address, TFTP address, etc. Phones connect to CCM and begin to download firmware image showing "Updating firmware...". Then both phones show same failure - "failed to download imag...
Dear All,I have call manager bussiness edition, and our user is having Error 41 - Temporary failure. I check on the CDR, a lot of user experiencing call terminate, and their phone is " configuring IP " status. Any suggestions what may cause this erro...
I want to set a background image for 7945/65 IP phones.based on the procedure I neet to create a subdirectory../Desktops/320x216x16.In Cisco Unified Operating System Administration I can not see any option to create any subdirectory.How can I set thi...
What I have now:H.323 voice dial peers towards every branch.The problem is that we start to grow too quickly.And I realize that it is difficult to me do manage all these dial peers. Someone said to me that gatekeepers is the solution.But I do not not...
Hi,I am having a CISCO 2811 with 8 voices FXO Interface. Currently only 4 lines are terminated to the FXO Interface (LINE A, LINE B, LINE C, LINE D). Out of the 4 lines 2 lines are dedicated to the bosses (Line A and Line B). Therefore only 2 lines a...
I have Cisco 3845 router with T1 PRI from Verizon, " show isdn status " shows layer1 active and Layer 2 " MULTIPLE_FRAME_ESTABLISHED "The ISDN layer2 change to " TEI_ASSIGNED" after applying MGCP from Callmanger ( Ver6.12) to 3845 Voice gateway. and ...
I just took over day to day operation of our phone system. I have an administrative assistant that has multiple shared lines on her phone. She wants those lines to forward to her extension (line 1) after ringing the orignal person and then return t...
Hi all i have tried to connect CCM to CME but it only works in one side : from CCM to CME it works well i can even hear my self in the other end however from CME to CCM i have a busy tone signal:the following is my configuration setup:On CallManager ...
