Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I try to install Attendant Console,I make all the settings like in this document: http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803f3a8b.html#wp293921. user: ac (accociate with ACpilot and 2 IP Pho...
hi when i have two NICs on my laptop one for LAN and the other for WLAN for ip communicator what should i configure in device name the MAC of the LAN NIC or the MAC of WLAN i've tested this when i configure device name of LAN MAC and i connected thro...
Got a question in regards to ethereal capturing a source and destination set of ip addresses that do not include the ip of the device that I capture on. Is this due to promiscuous mode?Say the capture nic card is 10.0.0.1 I am getting in some of the ...
When I try to pull messages from my voice mail from my 7971 I get no response from unity connection. Additionally When I log in to Unity I get no ERRORS. Any guidance as things to check would be greatly appreciated.
Hi All,Just spent a while going through previous posts and was very helpful to me in regards to how the Voice VLAN works.Now one questionIf the voice and data VLANs are setup and it uses a "special case" 802.1q trunk, can I assume that when packets ...
If an incoming call via an H323 Gateway is placed on hold after 10 mins or more conversation, the call is "lost", both sides getting white noise. If the call is placed on hold after 9:59 it's fine & can be put on hold again for up to 10 mins before t...
Is there a way to implement Forced autorization codes in Callmanager express 4.x?This is really urgent.Thanks.
Hi!Is there a way to configure an audio message that would be heard automatically if someone called the company out of working hours?
I need to get hold of this file to do some testing. Can anyone tell me where it is available for download kindly.tiaAjaz
Hi,can anyone point me to a url on cisco site where there is a guide on finalising the install on factory pre-installed call manager 5.1All i can find is documentation that explains fresh install.thanks
I have a customer that does not have enough switch ports and his budget is running tight. He was wondering if he can daisy chain the phones at least two phones to one port on the switch. He wanted me to find out if there "other customers" ran into ...
We have two remote office, Ohio and St. Petes. I cannot get the two offices to interdial each other. We want to dial just 4 digits to between remote locations. Will the following work:If i add the following Dial Peer to Florida dial-peer voice 87 ...
Hi,I want to upgrade a Cisco Unity express AIM-CUE software version below to Unity 3.0.1Installed Packages: - Installer 2.3.1 - Thirdparty 2.3.2 - Bootloader (Primary) 2.1.2 - Infrastructure 2.3.3 - Global 2.3.1 - Service Engine license 1.20 2....
I have a CME unit installed with a partial T1 or 11 channels. They have about 15 people so I think the ratio is OK. I am having issues where people are getting busy signals calling into the system as well as internel people calling 4 and 10 digit i...
Hello!Is there a way to authorize calls without forced authorization codes?I want to configure a phone to use a authorization code before making any calls(no matter where the call is being made - national, mobile, international).
