IP Telephony and Phones

Hi All, What will happen to SCCP phones registered to CME when the "SCCP Admin State changes to DOWN" which means SCCP goes down ? Regards, AK

Hi, we have an "issue" with hunt pilot on a cucm 11.5 environment. We created a Hunt Pilot with a Line Group. We can call the Hunt Pilot and one Line Group Member will answer. No Problem. What we want to do - we want to hide the number of the line gr...

Hi,     Skype configured in CME9.1.. But call not going outside. Hope you support. Pls find the below debug details. debug ccsip all        This may severely impact system performance. Continue? [confirm]        All SIP Call tracing is enabled    ...

Hello friends, I have one issue regarding Mobile Voice Access (MVA) number, from one network service provider not able to do successful call its just playing welcome IVR message and repeating dial your remote destination number so i contact to networ...

Hello,Following article https://supportforums.cisco.com/document/31996/troubleshooting-replication-issues#comment-12195936 I have tried with my client suggested steps to troubleshoot CUCM Database replication problems. But it does not solve all my cl...

Hello gang,I have a question regarding CallManager subscriber setup in either of these two scenarios: a total loss of a subscriber server, or adding an additional subscriber to an exisiting cluster.Let's say I use my 4.2(1) CDs to install a new PUB a...

Hi Everybody, Hope you all are doing well! I need installation media of Cisco Call Manager 4.2.(3), if any body have it please share it. Thank you in advance

hi All ,  i have 2 Redundant CM publisher and secondary with a version 8.5(installed directly on servers without Virtual machine VMWAre) , my customer has purchased new CMMBEK version 11.0. how can i import/export all configuration including ( pho...

Hello, when 7821 ip phones call an extension reachable  via ipsec tunnel, the far end phone rings but the connection goes out when the call is answered.(nothing is heard, the call drops when answered from far end) 7942's and 7962's are not facing an...

Hello, I'm configure the SIP phone CP-3905 , I have configure seval phone with IP address,mask and default router , but always stay states "Unprovisioned" , no dial tone, Someone can help ? I see that the "Active Server/Standby Server" maybe need con...

Hi :     I  just have a question about why does the Cisco ip phnoe 3905 only support three parties.    firstly, i had  a test that the 3905 had a conference as a host ,but the media stream that i see is from CUCM, however ,in CUCM,the max conference ...

We have Call Manager 5.1 and we are looking for a way to set Extension Mobility to automatically log out after 15 mins of Idle time. There is nothing listed for this in system- service parameters. Is there a way to set this up?Any feedback would be...

Hi Experts, I have CME with IOS version 15.5, E1, 2FXS Ports and 4 FXO Ports, and I configured all IP Phones by SIP protocole, I linked my Analog phone to FXS Port, the call from SIP Phone and cellphone work fine, but the call from Analog Phone to SI...

I have a homologation products, a final customer likes to connect sip phone meraki mc74 to another hpbx (asterisk), this is possible? please explain the answer and if alredy support documentation ? thank you