Other Collaboration Subjects

I've got a problem where my CCM v4.02(sr2) uses mgcp to a 3745 (12.2.8T5 IP Plus) that has 8 FXO ports for onnet and offnet connections. The call setup and routing works fine for both inbound and outbound calls; as soon as the 7960 phone answers the ...

hiI have two port WIC T1 card installed in HDV modules. But, I can only bring one T1 controller up. The other one always down. I am using T1 back to back. I am using 12.3.11T1.NewYork#sh isdn status Global ISDN Switchtype = primary-niISDN Serial1/0:2...

HiI am configured my phones for Manager and IPMA. but, i am unable to install the IPMA console application on the xp. All services, iis, tomcat are running fine.Any ideas.thanks

Hi, We are working on IP telephony solution between 2 locations, i.e US & INDIA.On the US site we hv the call manager, IP phones and the router with VWIC-MFT, the India site has only IP phones, the problem is can we hv the T1 termination directly on ...

I had an engineer tell me that if a person has a 7960 phone and they are configured for extension mobility that they can't log in to a 7940 phone. I believe they can and that they may lose line appearances but they get voicemail light and at least t...

Upgrade to Callmanager 4.0(2). Is it stable? what is the most recent stable Callmanager release. Can i back up 3.3(4) pub database using BARS. and import it on to another server which has 4.0(2) installed? any documentation would be helpful.

Hi allI have to upgrade the CCM from 3.2.3 to 4.02a. Well I know that the IVR and Extended Mobility can’t be upgraded automatically but are there any other surprises.It will be good to hear from other, there has been doing this exciting upgrade :o)An...

Hi,I have two sites each with CISCO2651XM-V-CCME bundle and nm-cue products. I believe the CISCO2651XM-V-CCME comes with 30 DSP channels. Is it possible to use these DSP to transcode the G.729 toll-bypass traffic to G.711 so that the remote nm-cue ...

HiI meet a problem. If I config a cp-7960 phone which ext is 3633 before. I want to config a 7970ip phone which is same ext number 3633. So I config the phone and delete the Cp-7960. the configuration is all over.however, I can not dial in this CP-79...

I have two phones on ports 21 and 22 that will not come up using in-line power. They work with power cubes. Here is some of the debug output for port 22. Do you think I need to replace the power supply and/or switch? I tried the phones on other ports...

Our telco provider is sending us the name and phone number via callerid. So far we are only able to see the phone number on our displays. How do I configure the callmanager to display this on Cisco 7960's?

When I look in to the device log from a phone (7960) I see :File Not Found: DISTINCTIVERINGLIST.XML Is there a explanation of this ?

I'm not sure why this is a huge issue all of a sudden, but in the last 2 weeks, I've been asked about making the secondary dialtone sound exactly like the off-hook dial tone. Apparently users find it annoying that it is different. Is there any way ...

Inboud calls from the pstnthru an h.323 GWrings on the other end of ip phone users, picked up, however there is silence, users had to hookflash once inorder to hear the caller.CCM 3.3(2)spC