Other Collaboration Subjects

Hello,where is the personal address book stored in CCM? A customer has installed a new CCM, now he wants to copy the old PAB entries of the users to the new CCM. Its only a test server so he didn´t want to update it.thanks Achim

Can the Call Manager be setup to pass name only on the display for internal calls only?

Hi,I have configured the MGCP on CCM 3.2 SPG and gateway with FXO card.I would like know all the information about the active calls which use the FXO card for example. - The extension number of IP Phone in use - The destination number . ...

I have two servers, one with CCM 3.3 and the other with CRS 3.0(2).IVR is configured on CRS and works perfectly, so JTAPI should work.I configured ICD subsystem with all users, icd extensions, CTI enabling, rmjtapi etc., and the RM subsystem is worki...

I have a Unity 3.1.4 server configured to support two CM clusters. Clauster A has first 8 ports configured for it and cluster B has last 4 ports configured for it. When a user in cluster A configures Viewmail to playback on phone they get error me...

Hello,does someone has experience with the scalability of Pilot Points- Hunt Groups.CallManager Version 3.3.2Server : MCS-7835I have found the following information in a datasheet of the cisco attendant console, and I am wondering if this is correct ...

I am looking at building a script that will decide between Site A or Site B skill based on Calls Waiting in que. If both skills have more than 2 calls waiting I want to send call to an alternate (third) site. Is there a way to look at "Calls Waiting"...

I got a 1760 with its 2.1, and I need to communicate with the other end -point.I have a 3661 which act as a gateway and has registered to a gk, what I want is to use this gateway to dial to other end-point. 3662 dial-peer voice 100 voip ...

I have Unity 3.15 with TSP version 6.0.2b. Call Manager is version 3.2.2c. Port 2 has been locked up for over 200 minutes. I have attempted to reset port from Port Monitor but the port continues to stay busy. I also attempted to reset the TSP but the...

I'm using CallMgr 3.2(2c) and I'm having an issue with hunt groups. I have small groups, from 3-10 users per hunt group, and as calls hunt from one phone to another, I have a strange problem. Once the call reaches the 13th phone, the call stays on ...

What is the major differences between Cisco VM and Cisco UM?Thanks

Hi there,Is there a way to configure which message classes Unity should consider of type "Fax"?Thanks!Kevin

Unity 3.13. When I call a subscriber's mailbox, the subscriber's greeting sounds just fine. However when the female Unity voice comes on after to say " you may record your voice after the tone...." it sounds very fuzzy and crackly. It doesn't al...