Other Collaboration Subjects

I would like to configue AA on a router with SRST. I am looking for something simmilar to "Cisco CME Basic Automatic Call Distribution and Auto-Attendant Service", which is working with CME. That means, someone calls in, hears the greetings, can choo...

Hi Everyone,I was wondering what advantage would one have in selecting the IP Voice (S28NIPV) vs Advance IP Services (S28NAISK9). From looking at the specification, Advance IP Services add IDS features.Are there any other functionality differences. I...

I have a CCM 4.1 system and am using 6 digit extensions 2digits i assign and 4 digits are sent from the phone carrior. In fail over if the line appearences are 4 digits it works fine but they will not translate to 6. I have tested the patterns and ...

When a caller comes in from the PSTN the receptionist will transfer the call. If the call goes to voicemail, the receptionist gets a callback from the original caller. There is no one on the line from this call. It's like CUE is letting the transf...

Hi all,I have about 8 phones that negotiate at half duplex even though switchport and phone are configured to auto.This is 8 phones in about 1000 - if I force them to connect at 100 meg by unlocking the phone and forcing the configuration to 100F it ...

Does vg224 (setup with sccp) support MoH multicast stream? Have tried in the lab, but it seems like doesn't work. Use MOH unicast stream without any problem. Thanks.

Problem with two seperate dial-peers. The config is below for the two. Essentially what happens is the lower priority dial-peer is chosen over the higher for some reason. when we shut down dial-peer 1780 the router then used dial-peer 1781.+++++++++...

CCME 3.3Unity 4.0(5)From a CCME 3.3 phone I want to directly transfer to a Unity subscriber's extension. In standard Callmanager, I am able to do this with a voicemail profile of *xxxx, and a CTI route point of *xxxx that forwards all to voicemail, s...

I want to script an email to be sent from IVR to Exchange (the version with Unity 4.x).What are the variables that need to be gathered?

Hi,I'm getting mad cause I don't find a valid configuration for T.37 onramp faxing with directly to the routers fxs-port attached Fax-machines.I tried on cisco1760 and cisco2610XM with IOS-versions 12.3(8)T9,12.3(8)T11 and 12.3(14)T5. Onramp script i...

I have a problem with transfering calls from PSTN to ITSP.Situation is like this:I have CCM 4.1, IPCC 3.5 and Cisco1760 GW. I have connection to one of ITSP-s which is working perfectly, but what I want to do is to transfer calls from PSTN to ITSP. A...

I know this configuration is not supported but someone told me that they had setup a 7914 expansion module to work on a 7940 phone. Has anyone else tried this and gotten it to work?

I am having an issue with all of my MGCP gateways failing over every 5 hours and 1 minute. Every 5 hours and 1 minute interval, I see that my last mgcp traffic elapsed time goes to 31 seconds and then they fail over. This happens on both gateways tha...

currently Mexico piggy backs off the back of California to get to our Headquarters. We are bringing them into a PIP MPLS config. Of Concern: besides pointing the session targets to the new Ip addresses. Shall I be worrying about the transition from p...