Dear All,I am seeking confirmation regarding the IE-3100-18T2C-E switch's capability to support dual Device Level Ring (DLR) network topologies. Specifically, I need to implement:A DLR network dedicated to IO-Link Masters (IO-Link Master supports DLR...
Hi, In FTD v7.6.2 I have and access rule to block incoming traffic with destination port ssh,rdp and telnet. but,upon checking the logs, traffics was block using this rule with destination ports for others not specified in the rule(dns, snmp,ldap etc...
The phone is registered to cucm now. From the procedure here. On CUCM phone's page you have to turn on 'Web Admin' and enter a password. But there is no option for that only Web Access. And that doesn't get you to the att console for the 9851. https:...
Hi, we are planning to config bgp peering with ISP for 2 internet lines. What public AS number can we use on our local internet routers? Need to discuss with ISP? Can someone pls advise? Thanks in advance!
I have install hyperflex 4.5(2e),and esxi is version 6.7 now I want to upgrade esxi form 6.7 to 7.0,but it error with "Failed to establish SSH connection to host: Host is not reachable, or in lockdown mode" I tried to add below config in the esxi ...
Hello! We have many devices affected by the clock-signal issues. Cisco does replace the units with repaired/fixed ones. I have received some ISR4321 routers with the fix applied (pictures attached). The Cisco provided fix is of - well - mediocre qu...
I am having a bidding project in which there is a processing capacity parameter. The assignment requires 2bpps but the device parameter is only 1.2 Bpps. I want to ask if using a 1.2Bpps device in that bidding project, will not meeting the parameter ...
Hello,I need you to validate an IP address because our school is under load balancing, and when you try to validate the IP, it says it doesn't match.Thank you very much.
I have set up my router settings with the correct 2 addresses.I have a network set up and when I identify my ip network on my devices it is coming up with the same one that is in Open dns dashboard. BUT nothing is being filtered. What am I doing wr...
I would like to change my primary email address.I did this at https://dashboard.opendns.com/myaccount/email and clicked on the confirmation link that was sent to me by email. I was then taken to the account overview page, but the email address is sti...
A while back I changed my email address, registered a new account, and removed the old one that had my IP address on OpenDNS, but now when I add a new network it shows that it already exists.My email: geraldoyt07@gmail.com
Hi, starting something new here and seem to be having an issue. My FPR1010 is set in PPPoE Mode and obtains a Static WAN IP as its GW and I also have a block of 8 Static WAN IP’s (6 usable). I was trying to assign a DDWRT router to an Interface on th...
Hello all,we are hit in this bug, we user ios 17.12.5 with all SMU. The standby WLC status was displayed as standby-hot when the show redundancy command was issued, however it is actually in standby-recovery because its data uplinks failed.as it appe...
