Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,We are planinng to upgrade cucm 4.0 (having three cluster) to 8.0. We have query regarding dlu, can we use same dlu with 8.0 or we need to purchase new dlu.Please suggest me if any document is there on the same.Regards,Dinesh Joshi
Whether phone number digits can be seperated with spaces or - or some such to break them up for easy to view. I believe its not, but still looking if can be customized in any ways.If you receive call and caller id normally displayed as 5551211234 wh...
Dear friends.. i know this topic has been discussed loads of time and if i try on google i can get hundreds of huge books on this topic .. but if someone can guide me in short how can i setup this .. what all things i need... sorry ... i know thi is ...
Hi I am using Cisco 2811 router to converge 2 RTP streams of different codes. I have scenario as below:SIP PBX-------g729------>CISCO2811-------g711------>CUBEI am using the universal transcoder, it does kick-in but no rtp gets established. Could som...
Hi all.One of my client has problem with call disconnection.When my client try to end outbound call, call connection is not disconnected.My client calls to my cell phone(or my office phone)and my client ends call.But in my cell phone, call is not END...
Hi ,We have CUCM 7.1.5 . E1 PRI integrated through MGCP. When we call from the mobile phone to DID numbers call disconnected with following Cause codes.0x80BF Service / Option not available. This is happened for some users only . For rest of the use...
Hi,We have enough resources ont he CISCO2811 router for transcoding. We have resources available to handle 30 calls but it does not take more then 16 calls. The issue of not taking more then 16 calls is now a challenge. Here is the output of the ' sh...
Hi All,Just wondering if anyone has successfully made calls from an EX90 via the PSTN when registered to CM8.6? Video calls over the WAN to other EX90's work perfect.I've made sure the correct CSS is configured but still not able to make calls.The de...
hi thereI need help with undertanding DSP and its usage....i have tried few docmentations but still not clear when comes to troubleshooting/Design perpective..is there any documetation that some can share that has very clear instructions...CheersMany...
Is it possible to have the CUCME system monitor the FXO port for a stutter tone dial tone? My telco changes the dial tone when they have a voice message waiting. Since my phones are IP based I hear the CUCME dial tone rather than the PSTN dial tone. ...
HiIn a Home Lab I am running CUCM 7.0 on a Virtual box with Cisco IP Phones 7941 & 7911. I did a factory reset on both phones with key-combination of # and then 123456789#0* . After the phones reboots it starts the upgrade process and is being the...
Deleted by poster
i have a Cisco phone 7941 connecting to a Cisco 2960 switch port. My voice vlan is 50 and data vlan is 1.the corresponding switch port settings are:interface GigabitEthernet1/0/30 switchport mode access switchport voice vlan 50 no snmp trap link-stat...
I have a user that wishes to have the ability to schedule a meeting through meetingplace (audio only, we do not have the webex components) and only when he, or the owner of the meeting joins does the meeting actually initiate. Is there a setting to d...
Hi All,Is it possible to forward call acording to calling number on cucm (version: 8.6.x) ?Problem detail is at below link;
