Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Did anyone know is the NIC card below is supported for Cisco UCCX agent voice recording?1. Broadcom Netxtreme 57xx Gigabit Controller2. Realtek PCIe GBE Family Controllerthank you.
Hmmm, I have two nodes defined in CallManager. It was good. I shut them down for a week and relocated them. Now second server isn’t showing. Trying a utils dbreplication repair all. Admin:utils dbreplication statusadmin:file view activelog cm/trace...
Hi - we have a 4 x node 8.6.1 cluster running on ESXI 4.1 on C210-M2 hardware. We have licensed the cluster based on the new VMware licensing requirements using the new licensed MAC process:http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/virtual/...
Hi,This weekend I installed CUCM 8.6.2 on the above server type, due to an issue with CUEAC and CTI route points I decided to start a clean install with a lower version of CUCM.I must have tried 6 different bootable disks at various software revision...
Friends, just looking for some feedback with regards to Changing ip address of Cisco Call manager. I have been following this document(http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/install/7_1_2/ipchange/ipchg712.html) to prepare for IP address ...
Hi,Am new to IPCC technologies. How to verify whether CCX is using IPIVR or cisco voice portal.Thanks & Regards,Raffi.
HII got new cisco 7925 when i try to connect to network it give registration rejected error message.I try to add the phone manully and it is registered.I have old cisco 7925 which are working fine with auto registration. but new one not able to regs...
Hello.I have a problem with 7911 IP phone. I have installed 2 new 7911 IP phones and registered it on UCM 8.6.2. They have successfully registered but the confugured locale have not been applied. I've done factory reset by 123456789*0# combination, t...
Hi All, I am facing an issue with CDRs CUCM version 7.1.5 the issue is the when i check the publisher or subscriber by running a query to check the contents of the /cdr, /processed and /preserve folder. I see nothing there for most days but some days...
Hi,FXO ports are installed in a H.323 GW and often it hangs after the call due to which we are unable to make calls. Everytime we need to login and shut & unshut the ports to release the ports. Any permanent solution to fix this issue...Thanks & Rega...
hello all,I have cucm 7.1 cluster with an h.323 gateway.I am having a problem with e.164 number.When im getting international call, i can see the full e.164 number in my debugs, but i am not able to see full e.164 on ip phone. on ip phone its display...
Hi!Does anyone know a procedure to globally change “15 minutes of computer inactivity” setting on cupc clients? I also want to globally change the default setting for “observe status when I’m in a meeting”.- Rune
Hi All,We have Unity Connection 8.6 integrated with a CUCM 6.1.5 cluster via SIP. We would like to introduce an answer delay for a specific group of people. I know we can create an answer delay via a port group, however I can't see how we can do this...
Hi,I configured AA on CUC 7 and anytime i tried to dial extension during the message i get the following prompt "you cannot be transferred to this number the line is busy"... but the phone is not busy ... secondly after the message i want the call t...
how to run 9971 phone and web camera logitech v-0012?
