Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I have been tasked with trying to figure out how many calls come into the building per dayand how of those calls go to a specific ext.or hunt group.Can somebody please guide me in the right direction either a white paper or through the forums on how ...
Guys,Have set up a CME in Germany with variable dial plan. Not easy. All is fine except for the outbound caller ID. The Telco says it is enabled but what is being delivered is missing the last digit for example when I call me cellphone in the UK i ge...
Hello,We need to perfrom an integration between CME and Panasonic PBX KXD-200 over SIP trunk. I ask if there is a configuration guide for that integration.Thanks a lot.
Hi, short question. Is it possible to deinstall / remove the Cisco Callmanager Program ?The Change/Remove button through ADD/REMOVE programs is not available.regardsPatze
Hi Dears..Is there any method available in CUCM 8.0 (3a) to change the protocol of IP Phones.All phones are registred with SCCP.I want to change to SIp for some testing.what is the solution...?Is there any other method avilable other than manually de...
Hi allDoes anyone have a guide on what files I need to install to set my unity express voicemail to UK English (automated voice says 'pound key' instead of 'hash key')Thanks!
Hello,I have to configure a kind of "Hotline Phone System" to have direct communication between two buildings. These two buildings have access to the same VLAN. Both phones share the same IP Network.My probem is that I cannot use a VoIP Server. Is th...
We purchase IP phone with RTU license and server support only DLU license ,Is there is any way to convert from RTU to DLU
Hi All,Anybody can help with disconnect supervision on my mgcp fxo port?I attach sh run and sh ver and wireshark busy tone.voice class dualtone-detect-params 1 cadence-variation 30!voice class custom-cptone tone1 dualtone disconnect frequency 469 c...
Hi. Does anyone know the process of moving users from a CME license environment to a CCM CUWL installation.
Hi,There are two user groups: Managers and Personnel. Only Managers group can call mobile phone numbers: 98... .......In every ephone-dn there is a "call-forward noan 98XXX XXXXXXX" entry where XXX XXXXXXX is the mobile phone numberof a particular us...
The CUCME System Admin Guide explains how to configure the CUCME, but does not explain the “why” these configuration commands are needed. I have gone through the “Configuring Conferencing” chapter several times – and am still with questions. Spec...
Hi,I have just been provided a new voice line by provider. I have put an initial config on the e1 controller card and once i got the Channel group configured I put a config on the serial interface. i am a little unsure of how to progress the config a...
Hi, how can i check whats the port speed negotiation by default on a CM 4.2?can i change this, by default?Thanks in advanceCesar
Hi guys,Has anyone seen this error in RTMT (Alert Central):SyslogSeverityMatchFound events generated: SeverityMatch - Alert mgetty[32057]: clean_line: got too much junk (dev=ttyS0).: SuccessThis Alert is appearing in syslog/RTMT every few minutes. It...
