IP Telephony and Phones

Working on a 2821 w/ a PRI to the PSTN and some SIP calls that currently all have a state of: State of the call : STATE_DISCONNECTING (9)Substate of the call : SUBSTATE_NONE (0) If I issue the command "clear call voice causecode 17 id X" or called-nu...

Hi Guys,just a quick question, maybe somebody had in the past the same scencario:Some users are working in a Hunt Group / Hunt Pilot witihin the same line group. The service is from mon-fr from 8am to 4pm and the using the HLog softkey / phone button...

Does anyone recall what service would use the CUCService application user?   I keep getting RTMT alerts that the account failed to authenticate against my IM&P node.   

I have doubt I have two E1 PRI line andis it possible to merge these two E1 lines..???If so, how we will configure PRI group timeslots ..??? whether it will show additional channels r timeslots in configuration..???                 

Hello All, I am looking for enable PIN protection in our Meet me Conference , Can any 1 help me to implement this ?  Thanks in advance . 

I have installed cisco jabber on my iphone5.finally it registers with the call manager. and i can make callsI tested the call to the internal extension it works fine but the issue is that they can hear  my voice but  i cant hear party voiceAll the Po...

Hello,Scheme:Cisco SCCP-based IP Phone > CUCM 9.1 w/ SIP Trunk > CUBE (28XX, 151-4.M7) > SIP ITSPCUCM Active Call Proc. Node IP: 10.10.10.9CUBE Inside Interface IP: 10.10.10.10CUBE Outside Interface IP: 20.20.20.20Cisco IP Phone: 10.10.10.8ITSP SBC I...

Hi, Recently in CUCM 9.1 I've configured a Hunt Pilot number with call queueing and I would like to also use call redirect option when no hunt members answer, are logged in, or registered. Unfortunatelly this option does not work as it should. When ...

Hi Guys, Do I need a CUCM to use an ATA 191?Can I use it to connect directly to a VoIP provider?Also, can the firmware be upgraded without a CUCM? Thanks,The ZMan

Trying to connect a Cisco 562 SB to 8851-k9. Receiving error of "Cisco 562 sb has been detected but is disabled by the administrator".  Phone Config, Enterprise Phone Config, and Common phone config all have the USB port Enabled.  If I use a third pa...

Welcome wherever you arecan one help me if CUCM ver 11.5 need the list.xml file to change/modify background image?and how can I download the list.xml file? Thanks in advance.

hello all. i'm trying to implement SRST on a 4331 gateway. this is an upgrade from a 2801.when we try to implement SRST i get this error%IPPHONE-6-REG_ALARM: 24: Name=SEP588XXXXXX Load=SCCP6945.9-4-1-3SR3 Last=Phone-Reg-Rejhere is my Fallback config!...

Hi all, We are using Ciso Packet Tracker and it seems it is using Oracle Java version 8. I need to clarify if we need to get additional license for Java in this case or is it included to the commercial license ? Thank you