Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
H323 with multiple PRI's. Multiple tenants are sharing GW. Need to configure outbound pots dial peer so that correct one is matched based on tenant. Would this be answer address? Thanks
Hi,When configuring a PRI on a AS5350XM, I got the following output when I do show controller E1 3/0 :E1 3/0 is down. Applique type is Channelized E1 - balanced Description: Vers Tunisie Telecom PRI 0 Far End Block Errors Detected Receiver has los...
Hi All,How do I verify the following in 7960 IP Phone,1. IP address of the phone2. CME software version3. Extension numberAnd how to access the GUI prompt of Cisco 7960 IP phone?Thank you,
Hello, my customer is asking me for the following configuration. For IP phones located at public areas : lobby, conference room, etc,that have a different DN associated, they want an Extension Mobility user log on to this kind of phones and then they...
Hi All,I use 26xx router. How can i verify the following software image presence and version,1. Cisco Unified Callmanager Express software2. Cisco Unity Express SoftwareThank you
I have been looking at adding MOH, Ring tone and a background image. I noticed that for at least one of these I need to log into the OS admin webpage. However, I was told that my login would not work for this site. What role do I need to be placed in...
Hi all,When I configure SRSRT I understand that it is an exceptional situation and therefore when a phone looses connectivity with CM and falls into SRST mode, it also looses a big part of its configuration. That is, CSS, hunt groups, pickup groups a...
I'm trying to access the Broadcast Message admin, my user have the feature to do that, but when i enter the user for the Broadcast Message admin, and then the password the system said "invalid user id or password". Im sure im using the correct user ...
Hi,I have CUCM7.0 and want to install TAPS applicaiton in UCCX5.0.2 box but I got the below error message."Error opening installation log file. Verify that the specified log file location exists and is writable"Advise please,
Hi,Have a bunch of analog wireless DECT phones that all connect back to an ASCOM box. The ASCOM connects to the LAN for connectivity back to the CUCM which is version 6.1.2.1000-1All of the DECT phones are configured as Basic 3rd party SIP devices on...
I have a DID trunk group of 4 analog groundstart trunk groups configured for wink-start signaling. Verizon now says for sure they are sending all the digits but I am not recieving them correctly, and in fact at this point am only recieving the first ...
Excuse my ignorance on the subject, but we have recently implemented a complete Cisco IP telephony solution, using Call Manager across dozens of sites. At our smaller offices, with maybe a 5-10 people, we have installed VoIP phones, connected via Cis...
Hi All,Can you please provide me the details on how to reset and reconfigure the Cisco IP Phone 7960G.
I have a hunt pilot forwarding to a supervisor phone after 10 seconds of RNA. Problem is that if the Sup isnt sitting at his phone the call doesnt go straight to his voicemail box. It just goes to unity and prompts the caller to enter the mailbox num...
hi,i have many client with cisco call manager express 7.0.1i copy the CME-locale-fr_FR-French-7.0.1.1.tar in flash:its/i execute the commande in telephony-service:user-locale FR load CME-locale-fr_FR-French-7.0.1.1.tar.i created ephone-template with ...
