Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,I am facing an issue where CCM user dials CME phone, the phone rings and caller gets ring back correctly but when called party (CME phone) answers the call, caller still gets two ring-backs and call get disconnected. Call flow:IP Phone --CCM--H.32...
I have a UC520/CME connected to a Centrex switch. With the previous PBX and with a but-set if you dial a long distance number, 9-1-234-564-7890, the Centrex swtich sends back a "tone" that indicates the user needs to then enter an access code. User...
Hi all. Im trying to set up bulk speed dials, as we have too many numbers for the local speed dial (35 max). I've uploaded a file called test.txt to flash. When I type in:bulk-speed-dial list 1 flash:test.txtI get the following error:MicrossIT(config...
I am considering an implementation of CME 4.3/7 with Unity integration instead of CUE. One of the requested features is Live Record. The CME Admin Guide says:"The Live Record feature enables IP phone users in a Cisco Unified CME system to record a ...
Hi,what are the configurations required for adding 7914 expansion module in CCME.A template would be highly appreciated.Thanks.Rgds./Sachin
i wanted to add some new ip phones on the call manager 4.1, 7911 and 7941 but the new phones are not registering but other older phones on the network registered.
Hi Pros,I have some problems with my CME box.For some reasons after some time, one or more phones that were REGISTERED and working fine suddenly appears like DECEASED (show ephone). The System was working fine for months and no modifications has been...
Hi, We have a requirement from a customer where we have configured several hunt groups. The customer wants to allocate a name to each pilot number of the hunt group. Thus if a caller is dialing one of the pilot numbers, the name of the pilot number a...
Hi all. I've just rigged up a 2811 with CCME. I've configured some ephone dn's and some ephones, all working fine.I've downloaded the SoftPhone. Ive installed it, but when i open it, it doesnt show me any lines to select.I've created an ephone with m...
I have a CUCME 4.0 setup with 7911s and 7941 phones. The 7911s are displaying the correct time, but the 7941s are an hour early. I found an article regarding this but it was for CCM, not CUCME and the resolution, a soft reset, didn't work.My time se...
Dear Networkers, Can anyone help me if we can use any non Cisco Wireless IP-Phone with Cisco Call Manager 5.3 and POE Cisco Access Point ? Since we have a security issue in our country and we cannot use the cisco Wireless IP-Phones, Thanks all
Hi,Running UCM 6.1.2 cluster.Currently facing some call drop issue.Please let me know how to see the logs in UCM 6.1.2 Server.Thanks & Regards,
I have looked for info regarding installingUPS client software on a CUCM 6.1 server.I assume it can be done and is supported. if so how?
Dear all : I have a question , I had set a forward (forward to 91370XXXXXXX#)on my extention 3013, if I call 3013 using other extention is ok, but if I call the service number 5809XXXX(in my 2821 gateway , I had set it direct to 3013)then I hear...
We have Two CCM (6.1)Clusters. Cluster A and Cluster B. Calls b/w the Clusters are working through ICT non-gatekeepers. However we would like to setup failover that if long distance PRI failed in ClusterA, we would like to route those calls to Cluste...
