Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
It says on page 179 of the CME manual that the monitoring of FXO status is possible. Is there a workaround to monitor which ISDN BRI channels are in use or to select them from the phone keys.
I have a remote VG248 issue.I have two ports going to one analog phone (Dual extensions on the phone)Port 45 -- Shows Link down (Ext 1009)Port 46 - Ext 1010when i go into port 45 it shows Call Maager Link downThe event logs show the following--- Port...
My company purchased CUCM6.0 Business Edition and finally received it. All I have done so far is put it in the rack and turn it on. I have also run the installation wizard that starts when you first start the machine.Now, I am configuring Unity Con...
Hi All,Anyone ever implemented COR for meeting place? I currently need to start allowing IDD calls to be placed from with a meeting but want to restrict this to certain users, any pointers on how to do this?Thanks,Warwick
I don't get how an FXO port connected to an FXS port can distinguish the DNIS. Shouldn't the FXS port just apply ringing voltage to the FXO port without any DNIS passing?Here is the scenario:VoIPphone------(gateway)FXS----FXO(PBX)----phoneVoIP phone...
guys i m trying to install CCM 6 on VMware 6.....now i boot the dvd and everythijg is done but at the end it says cant get to th edefault gateway (detect) guys i m using bridg connection t my physial NIC......now i have given ip adress of CCM 192.16...
I have customer who is on CM 3.3 and IPCC 3.1. I plan to upgrade them to CM4.2 and IPCC 4.0. Is there a better choise out there?
Hi,Is there a way to translate + in dial pattern, which is actually linked from Outlook to Personal Directory
Can some one tell me what cell phone make/model will work with CCM 5.1 or greater? I was told a Nokia E61 would work. My question is, if a cell phone has WIFI capability what is the deciding factor to make it work with Cisco Call Manager?
Hello,I've seen this setup before but don't know how to implement it, hoping someone here can set me on the right path. When the operator is on a call and a second phone call comes in we would like that person to hear the auto attendant say that the...
I configured 7 digits dialing as below but some dial immediately but some waiting 10 sec.-route pattern=9.@-router filter=(OFFICE-CODE EXISTS) AND (SUBSCRIBER EXISTS) Any idea to dialing immediately for all 7 digits?Thanks in advance,
What is the tolerance limit of Maximum Jitter and Average Jitter for Cisco IP Phones. The Call Manager version is CCM 4.1.(3). Currently I see Maximum Jitter 1 and Minimum Jitter 0 for I hit ?? on IP Phone. I haven't checked the other fields, but ...
hi all,we have call manager and we want to connect it to nortel BCM through sip trunk.now i want this sip trunk to provide me 10 MSN numbers in one trunk.same as we get in PRI (suppose 10 MSN and 30 channels).and i want to use this trunk on BCM. so t...
I need to connect two E1 cards back to back so all calls from CPE go out to the Service provider equipmentOn the Service provider equipment they have set up the followingController e1 0/3/0Ds0-group 15 time slots 1-31 type ext-sigFraming no-CRC4Clock...
I have two sound cards in my comp.Is it possible, with Cisco IP Communicator, to use one card for sound output (speakers) and other card for recording (microphone)?
