Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,I've 1 Cisco 7960 phone. I use it with SIP. The phone is "waiting for a call". So, when I call my number with my mobile phone, the Cisco 7960 rings. That's all good! But now: I'm thinking to buy 1 more Cisco 7960 phone. Same configuration. Same SI...
What does the following SMDI packet represent? MD0010013D 0002914Can you also please send me any URL where I can find more information
Does anyone know if Cisco switches support Alcatel phones for voice vlans?
callmanager 4.1.3 Server in cisco ip phone 7912 line configurationMessage Waiting Lamp Policy Not available on this device.how we can enable the Message Waiting Lamp Policy
DearsHow to configure 7914 on CME ( CLI commands) and how to use it ( it's operation. note that i have 24 ip phone and one 7960 which the 7914 will be connectedthanks
I was under the impression that directory queries on a CM network were LDAP based, but someone I know is insisting that the directory is downloaded as an XML file. LDAP or XML?
we have a isdn DID number from 3598300 to 3598399 and ccme, the incoming number 3598300 should be striped in gateway and only 300 should be matched and reach the phone with DN 300. can any one help in configuration.
Why is PRI the preferred method for interconnecting CM to PBX
I would like to have a sample configuration how this works.Let's say HQ is 2xxx and branch is 3xxx. What dial plan should I configure?
hello...anyone would explain how many telephone call supported when pvdm a has 2 DSP? what relation call with channnel? because i saw router has one pvdm but only say it support 32 channel. does it mean 32 call concurrent?
I will install one MCS-7816 with CMM, and wanted to know a little more about the hardware. I know that the machine will be an HP based on the product number, but I could not find any documentation for physical installation, expansion, etc.. Where sho...
Can anyone tell me the latest SIP files that are available for the 7961G that can be run on CME 4.1 on 2821 with CUE? What a confusing chart...
hi guys...what possible trunk can be connected between pbx and cisco router in short cable (5 meter)? is it E1/T1... ops.. by the way do we only need plain e1/t1 without kind of signal such pri? please help... beside that how dialpeer would map to th...
hello does the regular fxo/fxs dial-peer configuration configuration will allow us to fax without the need additional config? example configuration from you are welcome. tx :)
Hello,I installed the version 2.1 (beta) and when I run the audio wizard, I only get 1 choice for: Headset, speakerphone and handset = Default Windows audio device ???For the ringer, I can select different devices.If a say "next" it tells me that It ...
