Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

LMS 4.2 Change Audit Report

Hi,The audit/compliance department at one of costumer wants to see the weekly config change audit report.I have done  many test with this feature and i found two problems: 1. The given report path is empty. Only the directories  was made and there ar...

SNMP counter problem

Hi,i configured management program to poll MIB OID 1.3.6.1.4.1.9.10.19.1.1.4(cpmActiveDS0s;The number of DS0s that are currently in use.)Everything ok and i got what i want. But some polled routers increment counter and values rises day by day. After...

rmv72 by Beginner
  • 620 Views
  • 1 replies
  • 0 Helpful votes

Limit syslog email alerting

I have syslog sev1 and Sev2 email alerts enabled in my Prime LMS4.2.2. Is there a way to limit the alerts so that only one email gets sent for every 100 or 500 duplicate alerts etc.There are some instances where I received 5000 emails in one night fo...

nawas by Enthusiast
  • 839 Views
  • 1 replies
  • 0 Helpful votes

LMS 4.2 VM issues

The error below appears soon after powering up the VM which has LMS installed, after which nothing further can be done on the system.Anybody seen this before any hints on where to start troubleshooting.?

mariusst by Beginner
  • 426 Views
  • 1 replies
  • 0 Helpful votes

ChangeAudit Job LMS4.2

I scheduled a 24-HR ChangeAudit job and I clicked the link I recieved in the email and I get the following error"You cannot view the report since the corresponding archive is already deleted or not available"I thought that the bug  CSCsy03151 has alr...

nawas by Enthusiast
  • 568 Views
  • 2 replies
  • 0 Helpful votes

Resolved! LMS 4.2.2 Device Interface Monitoring

HI,On LMS 3.2 there was a way to disable the monitoring of Device Interfaces.Examples are ISDN30 Channels, which go up and down during calls. I could disable the channel monitor on the relevant device and only monitor the Circuit as this is the main ...

Ian Beck by Beginner
  • 1186 Views
  • 2 replies
  • 0 Helpful votes

EEM Without IPSLA

I'm about as green as you can get when it comes to EEM so I'm wondering if the following is possible w/out using IPSLA (our 65's don't support it).Basically what I'm looking for is a way to do the following:1.  Track a downstream, internal IP.2.  If ...

LMS 4.1 time zone

Hello!After a fresh installation of Prime LMS 4.1, the time zone of the application is different than the OS time zone (MS Win2k8), and I don't found where change the time zone of the LMS through the GUI interface.Follows attached a print screen, sho...