Other Collaboration Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

HiI am configuring a demo system on a 2811. The phones is 7960, 7920 and just about every model on the market :-)I have found the loud ringtones for the 7920 and the Ringlist.xml. Where do i find the other ringtones listed in Ringlist.xml ?The 7960 p...

pbuch by Level 1
  • 529 Views
  • 3 replies
  • 0 Helpful votes

Two questions for the group:1. The Call Manager Active Directory can store a wealth of information. Is there any "fast" way of populating all of the available fields?2. Cisco Web Attendant only displays four columns of data in the directory listing: ...

k6lw by Level 4
  • 449 Views
  • 4 replies
  • 0 Helpful votes

I'm trying to update the firmware on a 7960 from SCCP 5.3(4) to SIP 7.4.0. I've been following the procedure C described on http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/ipp7960/addprot/mgcp/frmwrup.htm#wp1048867but when the ...

gpena by Level 1
  • 420 Views
  • 1 replies
  • 0 Helpful votes

why would you have the following to dial peers - don't they overlapdial-peer voice 6... voip preference 1 destination-pattern 6... progress_ind setup enable 3 translate-outgoing calling 15 voice-class codec 1 voice-class h323 1 session target dial-pe...

Hi all,I have question about dial plan on routerwith CCME and BRIs instaled on the samerouter. Is it possible to use 4 BRIs on router with CCME and configure dial plan to route outbound and inbound calls through these 4 BRIs? If yes could someone giv...

johnleeee by Level 1
  • 317 Views
  • 5 replies
  • 0 Helpful votes

We have installed Emergency Responder and upload ALI information to SBC. When calls are routed throug CallManager the PSAP has the correct information. When the call is routed through ER the PSAP only has the billing address. We did a debug during a ...