Routing

Hi, I have a query as regds QoS. Say am an ISP and am prioritising voice traffic in my network by setting an IP Precedence value for voice traffic say X.I have many customers connected to my network. One of my customer wants to prioritise his Voic...

Looking for recommendations for books on ATM (Technology, and also Network Implementation(Specifically on Cisco gear) - Current ATM knowledge is nil ;)Came across "CISCO ATM Solutions: Master ATM Implementation of Cisco Networks", but it received mix...

Dear Support,I am going to implement DMVPN between three European sites (spokes) and a central hub in London.I have already bought the equipment 3 x 2811 adv security (spokes) and a 2851 with vpn accelerator card / adv security (hub site).I am just a...

Hello all, We have a 7507 w/ RSP4/256M and a VIP-2-50 w/ CT3 card running rsp-pv-mz.123-11.T3.bin. The CT3 card is plugged into an Adtran MX2800 DS3 mux. The Adtran is used to consolidate DS1 circuits from various carriers into a single Channe...

Hi.I have a 2811 ( CO ) with a 4-wire SHDSL interface connected back-to-back over a leased line to a 1841 ( CPE ). I have the line-rate set at 4608kbs and it works fine with no errors on the SHDSL interfaces.I then connected my lap to the 1841 f0/0. ...

Hi,Is it possible to define a range of ports, when configuring PAT to allow external Users access to an Internal Server ?E.g. I want anyone hitting the external interface address on ports 10000-20000 to be forwarded to an inside IP address on the sam...

Hi All,My new enquiry has to do with bandwidth allocation.My scenario is as follows:I am situated at the main site.My router is connected to other routers-sites, site A and site B. The connections are 256 Kbps and 2Mbps.My main site router is also co...

HiI have a router in OSPF debug mode.I received the message:OSPF: Rcv packet from 10.59.229.1 src not on the same networkWhat it means that?Thanks in advance for your help

In ISIS as of 12.2(8)T you can specify a broadcast interface as "isis network point-to-point" to simplify topology and achieve better convergence time as long as there are two routers on a ethernet segment. Can we do the same thing with OSPF?Regards.

I was wondering how I can provide the same subnet at 2 locations over the WAN? Is there documentation on ways to do this with routers or birdge's etc.

Hi,I have a Cisco 2610XM router in my working premise. We have planned to install 10 IP Phones in our premise. Can i deploy this solution without the use of any Cisco CallManager software ? What IOS do i need to have in my Router? Also we want the us...