I am wanting to set up a lab to set up and run python scripts for learning purposes. I have tried this a few times but want to ask the community if there is a Best or recommended node to use to push the scripts to switches and routers. If this is too...
[FSM:FAILED]: downloading Image Dom.xml from local(FSM:sam:dme:FirmwareDownloaderDownload).Remote-Invocation-Error: Unable to open downloaded Image# ID: 1308401Fabric Interconnect, Cause: fsm-failedCode: F009690Severity: Critical (all levels) I am ge...
Hello, I'm trying to convert my template-based configuration to use Configuration Groups. It's a two-router site with several TLOC extensions between the routers. With the template-based configuration, I add a static route in VPN0 to the other side o...
Hi,Has anyone been able to successfully deploy ISE in Azure using expressroute from on-premise to the cloud.We have had ISE running in Azure for about 3-4 months now and have noticed a large amount of fragmentation using EAP-TLS. The Cisco guide sugg...
I am labbing EVPN Point To Point VPWS for my CCNP SPCORE test and I was able make it work between two routers with IOS XR NCS540, but when I tried to do it between IOS XR and IOS XE the P2P comes up and I am able to see mac address on the local CE of...
Hello,I’m locked out of my Cisco SG250-50P switch. I do not want to reset to factory defaults if possible, because I need to preserve the current configuration.Is there a password recovery procedure specific to this SG250-50P model (to regain access ...
9800-40/80 17.15.4 running local MDNS gateway drops all MDNS advertisements, services are being learned and cached correctly from wired sources but advertisements are always being dropped before they go out to clients. Can observe this happening in m...
Hello, We have CoreSwitches configured as DHCP servers and Layer3 for several Vlans but we started noticing DHCP timeouts and after analysis we found out that devices are sending a DHCP request almost every 2 minutes even if the lease time is configu...
We purchased some Grandstream WP825 wireless phones to try to integrate with our CUCM 15.0 configuration. We've been running C7925 phones for years on older CUCM versions, and while we've had reasonably good luck with those, the audio quality just is...
Hi, Would like to check if you experience this in your ACI. Currently, we have OOB with 192.168.0.0/24 network and I need this to be reachable with the workloads hosted in ACI (overlay or ACI as a gateway).Thanks.
As part of our ongoing global expansion, Cisco is launching additional data centers in the coming weeks and months. To support this growth, we are introducing new egress IPv4 address ranges for some of the new data centers. What’s Changing? We are e...
Hi CX Cloud Team! I’d like to suggest an important improvement for vulnerability management in CX Cloud. Currently, the way vulnerabilities are handled and displayed on the platform does not meet day-to-day needs well.I have to navigate through multi...
I'm trying to allow UPnP ( I know - bad, don't do it, unsafe blah blah) on a single vlan dedicated to gaming. I've got a pfsense firewall with upnp enabled handling all traffic for this vlan to the internet. access switch (VLAN122) -> Core Switch ...
I am experiencing the issue described in CSCwo61235 in the field. My deployment uses this Cisco kit pro as a standalone Microsoft Teams Room and it is not registered to Webex Control Hub. As a result, I am unable to access or download the software re...
Hi team i have a problema to relaunch the Network Services Orchestrator 6.4.44 days ago i launched succesfully this service but now i want to work again with the NSO but i have this problem when i try to relaunch for 2 more days:Something went wrong....
