TelePresence and Video Infrastructure

When I add a system to TMS, it doesn' talways appear in the Navigator.  It doesn't show up in any searches.  It may or may not show up in the system list if I try to purge it.  If I attempt to add again, TMS will indicate it is already in the databas...

Hi everyone, Let's assume that I'm not interested in any user using Jabber for Windows at a higher resolution than 448p for bandwidth reasons, is it possible to enforce this through CUCM? I'm not referring to a location based solution where it looks ...

How do you calculate the re-certification fees on a Cisco telepresence system if you want to register it for a new 12 months?

Hello everyone, recently, I have been notified by end users that some endpoints had something wrong It is said that they didn't work properly during video call. So I went to the logs of my telepresence server and I noticed the following:due to the de...

Hi, we need to upgrade a Tandberg Edge 95 from the F8.2 to the F9.3.3. The equipment is not under a contract service, so we are not able to generate a valid release key for the F9.3.3Would appreciate any suggestion.Regards,

Hi all. I'm only in my CCNP studies. I have however spent the last 3 days researching QoS for a 6509e quad 2T sup VSS core. I apparently cannot do MQC QoS on this setup so PFC QoS is what I'm doing. Class Map type lan-queuing match-all VOICE (id 38) ...

Hello. I have VCS Expressway X8.1.1 that sends some of the calls through specific tunnel (and not over the internet which is a default). For these calls route is upc_FW_Traversal -> Zone001ToTraversalSZ -> TraversalSubZone -> Zone006ToTraversalSZ -> ...

Hi,I want to confirm the Expressway cluster requirement.According to the document, I can see the cluster requirement as below:1. Routable IP (Layer 3)2. 15 hop & 30 ms RTT But I cannot see the bandwidth requirement on Cluster. Any idea on that?As the...

We have a TMSPE (14.2.1) that manages our endpoints which are registered to VCS-C (8.2.1). We have three Polycom endpoints (HDX 9004, HDX 8000, and a VSX 8000) that are unable to be managed from TMSPE.TMSPE reports a "No HTTP response" message. This ...

HiWe have cisco profile 42 with C40 codec and software version is 5.x.in every 15 minutes system continously get restart.please suggest what should do.  

I currently have an EX90 setup to take receive video and output it over the HDMI out connection (in addition to the internal monitor) - pretty much whatever is on the EX90 monitor is also spit out over HDMI. I now want to record the HDMI feed on my A...