Unified Communications Infrastructure

Is there an ability to insert a pause into a created contact in the CUPC 7.1 client. Basically what I'm trying to do is the equivalent of putting a couple of commas into an old modem dial string. One of the folks here has created a contact to dial in...

ip source-routeip cef!!ip dhcp excluded-address 192.168.0.129 192.168.0.135!ip dhcp pool Phone   network 192.168.0.128 255.255.255.128   default-router 192.168.0.130   option 150 ip 192.168.0.130!!no ipv6 cef!!!!multilink bundle-name authenticated!!t...

Hi,Is there any way through which I can get the serial numbers of all the cisco IP phones connected to CUCM ver 7?Faizal

Hey Guys,My question is in regards to creating different presence groups and having default contact groups when a users loads the CUPS client.For example I created marketing, accounting, and finace presence groups.  So when a user loads the CUPS clie...

Hi,I am planning to deploy 4 small sites (50 to 65 users each) and interconnect them for IP telephony.What came in my mind was to use ISR routers with CCME software on each site and provide unity for voice mail feature as well, on each site.The only ...

Good Evening.I am not sure whether my question is repetive but I am having following scenario and no idea what's the option left towards implementing this:-For the existing system, for Any Long distance and international call the company user gets tw...

Please can anyone helpI am running Cisco 4.3  call manager and I have BARS 4.0.13000 which has been working fine till a few days ago it started giving the error below when I run the Backup" Could not build archive successfully."Can anyone tell me wha...

Hello,We have a newly installed Cisco unity server with software version : Cisco Unity 7.0 Build 7.0(2) and we have intergrated the Unity server with IBM Lotus Domino.The unity server is functioning properly but yesterday a problem started with the ...

Hello, we have a current user of CUCM 6.1 running in MCS 7816 with 80 endpoints. if I would upgrade them into version 8 with new server MCS 7845, can I use the 3 dollars per endpoints with 3 years UCSS option?Regards,

How many simultaneous lines will be supported between FXS port and PBX? please reply

Hi, just installed the cupc 8.0 but cant get the softphone up and registered, it seems like the softphone is disabled in the client.Anyone have any nkowledge about this and any configuration tip / places to check ?I have run the troubleshooting tool,...