Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi I am running CUCM 9.1.1. I have configured directed call park number 7800 with a retrieval prefix of *73. On one of my directory numbers 7777, i have call forward no answer set to 7800. When I make a call to 7777, the call successfully goes to 780...
I have a user who wants to forward his phone to his cell phone. Normally this would be no problem.Basically this is the scenario:User A has an phone number of 555-555-1234User A forwards his IP Phone to 555-555-1212.When User B 555-555-9876 calls U...
HiWe have been asked by a customer if it is possible to forward a call using call forward all, and still display the original caller id.Basically the system forwards all calls after hours to a mobile. But the customer wants the caller's number to dis...
Hi Support Community We have implemented Citrix Netscalers on our LAN and I am going to take advantage of them for some voice services, in particular Extension Mobility. I cant find it documented so hopefully someone with experience can advise me : ...
Hi All I am in the process of setting up CDR for billing purposes using 3rd party app - SmartBILL In my CUCM i have different route patterns for International, National, Mobile, Emergency, Toll Free calls. How can i reflect this call type/classific...
I need to integrate CRM with CUCM (Call Manager) is possible? What are the necessary settings? I need documents sources quanton it.
I am using firmware 11, but seems buggy. Is 10.3 recommended for use with CME10.5? AT
Hi, I have used self provisioning several times now and in general it works very well. I now have a situation where we have a new system where all users will use Extension Mobility. Is there a way to use self provisioning and create automatically a U...
Hi I have multiple CUCM 9.5, these are distributed over the WAN in around 34 sites. All these locations have PSTN calls from the local site gateway. I have existing billing server in our HQ site only for the HQ CUCM, we would like to incorporate o...
Hi, Is there a way for applications that require Cisco TAPI to point to more than 2 x UCM nodes? ie CUAC Standard, 3rd party all recording Thx
Hi , We have an IP telephony setup running on CUCM version 10.5.Our client has new requirement which is mentioned below.Client don't have Unity. For example User A using IP Phone which is registered on CUCM.If someone call User A and if User A is bus...
I am trying to implement SIP EO on trunk from CUCM to CUBE.I enabled SIP EO in sip profile (Insert MTP if needed)To test I use CIPC version 8.6.5.0.I notice diffirent bihavior when calling from CIPC over SIP trunk.When I enter number and press DIAL b...
Hi everyone, If I am able to calculate the number of UCLs I need when migrating from DLUs to UCLs, is it enough to create a request via PLM and send the request to Cisco without a report from the License Count Utility?
I am migrating the current 8.5.1.10000-26 to virtual platform with ESXi. On this case the MAC will be different so I would need another license file. But is possible download the current .lic file from the physical cucm? I have found only the option ...
Hi I have CME with two IP Phone IP Phone1: 172.16.15.5 CME: 172.16.15.6 IP Phone2: 10.10.10.2 IP Phone2 have 10.10.10.2 and after NAT have 172.16.15.8, the problem I faced is the phone 2 can ring but not receive any Media only send, How I make Pho...
