Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
We have a single cluster in which CUCM,CUC,UCCX,IM version 8.6 installed,when i upgrade only CCX to 10.0 will it be compatible to CUCM or Should i upgrade all the the servers in cluster,,,,advice me on this.
Hi, I have one site consisting of 250 users and 2 sites. Regardless of geographical location, what is the best practice of design. I mean to say, Shall we go for server based solution or router based solution.and what other parameters do we need to c...
I have tried to register cisco VG224 to CUCM 8.6 like MGCP gateway but it fail to register, any idea why this issue?
Hi,I am searching on google and cisco community about the installation and working of CIPC on ncomputing devices. As i have a doubt about installation and working of it on ncomputing.Regards,Shahzad
I have a Cisco IP 7961 with a 7914 Expansion Module and I need to change the staff speed dial names. I've printed off the manual but I can't figure it out?
Hi, I have an IP Telephony setup with 3 CME in differnt location with 3 CUE which currently running.Now client has planning for an upgrade for Multi site with centralized call processing deployment model. That means one CME will convert to CUCM, an...
I have voice router 2921 CME 9.5 .My ip phones registered in it.I have configured telephony-service.But my phones shows me different time than in configured CME.some of them can display 2 hour difference ,another 6 hours.I tried to upgrade phones f...
Hi,I have callmanager 10.5 with LDAP. I want to import users and assign thse users to an access controll group (like ccm enduser etc)I configure, I import the users, but they are not member of an access controll group and I have to do it still manual...
Hello, I would like to know if theres any way I can use the cucm 8.6 to send a broadcast alert to all phones? Thanks all.
Hi guys,we have configured the CUCM with internal database but we want to use an external attribute from Active Directory (Username) and pass the attribute (as displayname) to the CUCM? Thank youFabrizio
CUCM 10 with an 8945 SCCP phone. The phoen has the message light on, but I see no reason why it should be on. There's no voice mail connected with this phone but the red message light that shows through the handset is on and there's a red message i...
dear all i have a cisco router 2811 i need to config sip trunk and call through fastethernet port is that Possible or must have e1/t1 card if possible please help thank you
CUCM=> SIP (MTP checked)=> CUBE=> ITSP call transfer is not working if MTP not checked. The issue is after each week or so call transfer does not work.I checked MTP using RTMT and it shows all session are used. So I always need to reset it. I also t...
Hi How can i disable transfer feature on 7906 phone ?Thanks
Recently, I checked the License Unit Report, I found the "Software License Version" is missing. I guess it's using temporary license from the beginning. I would like to purchase a permanent one. Do anyone know the Product Name and Part Number which I...
