Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi There,Is there a particular code in Call Manager or UCCX which will show whether the call was terminated by the agent or by the caller?As my understanding, either party end the call by hangup, the Call Manager will show the code as norma...
Hi All,i am currently using CUC9.1.2, and reg with 270 users.And right now we are plan to update their greeting to standard company greeting for everyone. is any way that i can bulk admin to do it instead to config it one by one.thanks alotsimon
Hello Community!We have a security requirement that require all our UC Apps (CUCM,CUC,CUCCX etc.) to have its admin passwords to be change annualy.I'd like to know, will there be any impact on these Apps' operations (will it cause downtime, complicat...
Hi I have two cluster cucm 9is the call back works over the cluster? Is there any way to configure it?Thanks
I have a new Sales department and they want to be able to call 6 different areas, in which we have a local presence, and have a local number show up for Caller ID and return calls. I have setup a separate Partition and CSS for these users...
Hello,So under the SIP trunk configuration - Call Routing Information - In CUCM, the "Remote-Party-Id" and "Asserted-Identity" check boxes are both checked and the "Asserted-Type" is set to "Default".However after looking thru enterprise parameters a...
Good day!Today, i've configured an outside route pattern to PSTN (through CCME-2901 - Gateway)Route pattern - 9.8XXXXXXXXXXCall Classification - OffnetChecked - "provide outside Dial Tone"And Configured Called Party TransformationsDiscard digits - "P...
Hello, I have a cme with sccp phones and a sip trunk.The sip trunk provider is blocking the incomming calls and send me this log:[Feb 17 09:48:39] NOTICE[5853]: chan_sip.c:24929 handle_request_register: Registration from '<sip:7640@10.8.225.10>' fail...
Hello.I get the following error in CUCM 9.1. I see that the license is over and I can not provision any more clients. But how can I delete some phones and add new phones to adhere to purchased licenses???
Does anyone know how to get a demo license, or activate the embeded license for Unity Express 7.0. I see lots of articles about 7.1. All them have you use the commands starting with "license". If I do a ? at the executive prompt, or config termina...
Hii,I want to activate BRI for a video Conference ( Athera Vega X5 ), any information/steps will be very helpful.Thanks
Hello,I am working to create a SIP trunk in CCME 8.6 (c2851) and an ASTERISK server. Everything is fine but I have a doubt.For incoming call to CCME (ASTERISK to CCME), Cisco always accepts calls even if ASTERISK server is not registered.There is no...
Hi all,I'm trying to configure a 2921 Cisco voice gateway to place mobile calls trough an analog CellRoute 3G GSM Box. ios is c2900-universalk9-mz.SPA.152-4.M4.bin. FXO card is VIC2-2FXO. Till now I get only a fast-busy tone on every outgoing cal...
Cisco ATA is registered on call manager, fax are not working.When we connect analog line, it does not give any dial tone
I have a user (User A) who needs to transfer an outline on her phone to another users (User B) phone. On the User B phone I changed the outside line in the AAR Destination Mask and in the external Phone Number Mask in Call Manager Administration....
