Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello!We are currently using a voice translation rule to reject calls from specific numbers at the CUBE level (see attached screenshot), but we have reached the maximum (100) and I haven't been able to stack multiple voice translation rules on the in...
Hi,I don't why I can't access by browser to my cisco IP phone 7940, I can ping phone's IP address but don't access by browser. The firmware version Information is:Application Load ID: P0S3-08-2-00Boot Load ID: PC030301DSP Load ID: ...
HI, we have project requirement to integrate the Iridium Satellite phone integration with Cisco PABX to make a calls in case of emergency. Can you please suggest, what can we achieved with this interface.1) can we make calls on any number at cisco PA...
Hi, One of the our client want to use Different make WAN router (not cisco) for WAN connectivity. At the same time, they wanted the backup call manager option for their cisco phones. Can we use SRST router somewhere middle of the network without any ...
Hi, We have Branch office and Head office sites. At head office, we have Cisco CUCM application running and at the branch office, we have SRST router 1 and 2, both connected to head office over WAN. SRST router 1 should come in to picture when there ...
Hi, I have a CUCM 12.5 system where a Call Pickup Group is not working as it should. I have checked the CSS and Partition setup and all phones are assigned CSS's which have access to the Partition containing the pickup number. However when I use Dial...
Hello, I need help to configure a dial-peer on ISR 891W, when I try to configure, the command doesn't appear, the device don't support it? or there is other way to configure a SIPTrunk on this device?Router(config)#dial-peer ?% Unrecognized commandRo...
First of all, this physical phone belongs to the number ending 7201. After attempting to log in for testing, it changed to the user profile instead of mine. Additionally, the Extension Mobility Service is missing in the user profile with the number e...
Is it possible to configure a hair pinning config where two IP phones try to call each other via the same Gateway without configuring a POTS dial peer? What are the relevant configs for MGCP / H.323 / SIP Gateways?Any help would be appreciated. RS.
So I have a Cucm with 8300 Router with a PRI. Very straight forward setup. We got some Cube licences and the Microsoft Teams license to enable Direct Routing. Is there any document with example on how i can Trunk the Teams and the Router, so I can ma...
Hi, I recently purchased a new 8861 3pcc K9. It is asking for an activation code. I purchased this phone for my small business and I'm the only user. I can NOT figure out how to find this code or get past this. Thanks in advance for your help.
Hello everyone,I'm writing code in python using sockets to be able to AddChannelRequest, GetChannelSetRequest, UpdateChannelRequest, DeleteChannelRequestSo far we were able to AddChannelRequest, and the other requests are not working(we get errors re...
Hola tengo una actividad, hay pocos recursos claros en internet sobre este tema de troncalización de Cisco CME a Issabel u otra plataforma Asterisk, tengo dudas si la configuración es correcta con esta página o que más necesito, solo deja que Zoiper ...
Hi Together, i'm having problems with configuring BLF on 8851 3PCC with Asterik System. BLF are blinking and when pressed i've getting failure "Invalid Number". Software Version: sip88xx.11-0-1MPP-477.loads Voice with no problems, Calls possible ...
i want to login phone adapter configuration utility of this device, cisco and cisco can login ,but can't chang the set.
