Hi,I have added a new ATA187 in a CUCM but is in unknown state, it is unable to get an IP address. Now is connected in fa0/18 in my Switch, how can add a static IP through a remote console? is possible ?Thanks!
Has anyone else noticed problems upgrading 7941 & 7961 handsets to the latest 9.2 firmware ? We'reseeing problems where phones report "Unprovisioned" after upgrading. Yet, a firmware reset (12345...) fixes the issue.GTG
Hi, I have a situation that both POTS dial-peers and SIP voip dial-peers have the same destination pattern on C2801 which is acting as an IP-IP gateway and MGCP gateway, whenever SIP calls come in from CUCM, C2801 routes the call to POTS dial-peer, h...
Hii have CUCM cluster 8.0.3 working as centralized call processing and i have remote sites with IP phones (7911, 7942 and 7945) plus ATA 187 (version 9.0.3)the phones are working fine but some ATAs are unregistering and will only register with power ...
Hi Cisco Community!I am new to inbound/outbound SIP being used with the CME on a 2951 router. I've made good headway, and have configured the trunk and voice peers. I see the inbound calls coming to the CME via the debug ccsip calls command, but th...
Hey guys,at the moment i try to configure CUWL Premium in CCW Configuration Tool but dont see the new CUWL Product ID. Just CUWL STD aned PRO.Can anybody help, how to configure the new CUWL Premium for CUCM9?Best RegardsDaniel
Dear All,Recently the CCM service got crashed, on investigation we found, there is no issue in the CPU or Memory utilization, only thing I found was lot of H225 ICT Throttle Timer restart(0) message before the CCM service was crahsed, below is the SD...
I have about 4 8961 phones at a remote location. When the users come in every morning the phones say 'not registered'. They have to reset the phones to get them working again. I also have 79xxx and some 6945 phone on at the same site on the same s...
HI,I am currently running Call Manager 8.5.1 on a standalone MCS 7825 server. I plan to migrate from this to a UCS server. I have backed up the current server via disater recovery process and successfully restored to the new UCS server. My question i...
Hi AllI have a client that want to use CUBE to sit between two CUCM clusters because they have overlapping IP address. Has anyone heard of this before or know of a better way to deal with this situation? If someone done this before can they share a...
Good day!Can anyone support me in configuring SCCP client (Cisco IP Comminocation) at home with my CME 2901?CCME has an interface with public IP (routing and etc is configured already), i can establish ssh session without any problem.Will such connec...
Hi all,I am experimenting in our lab with using ENUM lookup and a CUBE (3845 with IOS 15.1(3)T3).I have followed the document posted on the Cisco example configuration website: http://www.cisco.com/en/US/products/sw/voicesw/ps5640/p...
Hello All,I am currently trying to investigate and collaborate the required procedures to upgrade a call manager business edition CMBE 8.x server to a fully integrated Call Manager (CUCM) solution 8.x or 9.0, in particular relating to licence transfe...
Hi guys…Is there any way that anyone can think of to provide the ability to call forward a shared line on a handset without using the CM User page?I.e. 7942 with Line 1 as their personal line and the line 2 as shared line. At present, pressing the ca...
