IP Telephony and Phones

I have configured AD syncrhonization of AD users to CUCM 8 with no problems but can not seem to synchronize Contacts.  My authentication is configured for userID, which is important, but contacts do not have a userID since they are contacts (of cours...

Hi all, i used to have 4 3911 in my CUCM 7.1 working fine for 2 weeks!! I also have 2 spare 3911. Suddenly, one of them started restarting but not the usual way;         it only shows a cisco logo (i cannot press any button) for 10         seconds an...

We have some branches that have Tandburg vidio phones and they call a remote branch when the remote party picks up the receiver.We have one phone that when the Tanburg calls the branch office, the cisco phone in the remote office rings, but then just...

I have a customer requirement to restrict the display of forwarded number. Here is an example of what I am trying to accomplish:User A calls User B (User B has his number forwarded to 305-555-3999 a personal cell number)User A sees on his caller id t...

Hello,I have a scenario where incoming call needs to ring to both manager and secretary phones at the same time, in the event that nobody answer than its going to hunt to a group of 2 secretary. I was able to accomplish this building 2 line group . m...

Hi everyone.I've been asked if it's possible for a 'loud ringer' connected to an FXS port (SCCP or MGCP...I can configure it either way) can be set up to ring when either of a pair of IP phone extensions ring. Any suggestions?Thanks,Felix

I have had to turn on our old Call Manager 4.1, to retreive some phone data, I have not used it for a couple of years. and I have forgotten my admin password.  Is there a way to recover it?

Where can I find documentation on how to design/configure/install two sites using 2 separate platforms? One using a Nortel BCM 450 and an ISR using CME and CUE?

All, I have a few questions that I need some help with.  I am putting in a CUCM 7.x with a remote site having an 2911 for SRST.  But the SRST function is supposed to be CME and not the traditional SRST that Im used to thinking of (as a MGCP gateway)....

Does resetting the subscriber password start the clock again for the "days until password expires"  account policy?

Hi all,In my VoIP network, I am using  CUCM 6.1 and Cisco IP Phone(7931/7911). I have two MCS 7835 Server( One is using as Primary and another as Secondary).Some of the Phones some times getting down and showing an error message "UCM Down". and after...

Guys,ill be brief, i just deployed two sites with the above and everything is working except MWI. before deploying we did this in the Lab and it works (actually i have it here again and its working). i checked my CTI CSS and my phone CSS and its fine...

Hello,i'm using CME (version 12.4(15)T5) togethet with 2 softphones (xlite and eyebeam). When i place an internal call between both softphones I dont get any audio.Also with an external call I dont get any audio.Can someone help/advise?regards, Marty...