Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Im trying to establish a SIP trunk between a lab CUBE and a SIP provider.Incoming calls works from ITSP PSTN to the CUBE.From the CUBE to ITSP call doesnt workI spoke to the ITSP and i know the reason but dont know how to implement it on the CUBEIm ...
Hi,I use Cisco 2801 with CCME, While Cisco IPT 7965 register a 7965, We receive a below messages,"SEP001XXXXXXXXX.cnf.xml" "No CTL Installed" "File not found: CTLFile.tlv Coul you please hel me?Thank You,M.Kemal Yenigün
Hello, I have 2 Cisco MCS 7800 call managers. One is provider and another one is subscriber. Subscriber is okay but provider is not booting. Even I cannot ping the IP also.I need your kind instruction to fix this. Please check attached file for more ...
I'm not a tech expert. The Mrs has a work issued 7961 and they're cheap. She now works from home, and they are having folks work at home one day, then in the office the next. They expect the staff to carry the phones back and forth as each phone is e...
Hi, I have a 29xx router (relatively modern IOS) with a single PVDM3-16. It's the media resource for a CUCM. According to the DSP calculator, a single PVDM3-16 for a low complexity codec can support either: i) 8*8-party conferencesii) 6*8-party confe...
Having trouble getting the 7941s to make conference calls i.e. joining a third party after both have answered.
Hi AllWe recently had a Tannoy PA system installed, however it does not seem to work when connected to our telephone system via a VG204 FXS port, we can plug an analogue telephone system in and it works fine. The system it plugs into is a Baldwin Box...
can anyone elaborate on this? LastOutOfService=17I have multiple 7925's and 8821's dropping calls. I've noticed in the debug display that they all have multiple instances of this out of service code. What causes this? Where should I be looking ?
Hi everybody, I have the following scenario: IP Phones (7821) - CME --- (SIP Trunk)---- PSTN. The outgoing calls are well, no problems with that. But in the incoming calls in first case (With rel100 enabled) doesnt establish calls. Ok, in SIP-UA I ha...
Is there a limit to how many times a call can be forwarded? For example I have a room of phones that are only used for specific events. When not in use those phones are forwarded to another number. However that number also gets forwarded off. So exam...
Hello, We have SIP trunk between two sites, the voice call working normally but when tried to use video call it working for just 1 sec then it disconnect. Do you have any idea? Appreciate your helpThanks
Good afternoon, I am organizing telephone support for sites, the company that contacted me uses your CP-8865-K9= phones and want to connect these phones to the network of their sites, for example - https://1x-rate.com/, I find this - https://www.cisc...
I have recently purchased two Bluetooth headsets the Jabra 45e and the Jabra Elite 85h. I can easily connect them to the computer audio and phone apps work ie. youtube or Microsoft Teams but I have issues with Cisco IP communicator. It will connect...
Hello everyone, I have a bizzare problem with a Cisco CP7911 running SIP firmware SIP11.9-4-2SR3-1S. After updating, these phones are stuck in 2008 and don't update their date/time. I have tried several different Timezone settings and a couple NTP se...
Hi AllWhat commands can I use to check a port on an analogue gateway is picking up? I did a debug signal vpn and got the following, can anyone explain if this looks ok and the call has picked up? 000163: Jul 2 11:32:42.748 BST: htsp_timer_stop3 htsp...
